Crankshaft
Show/hide table
| |
| Illustration 1 | g03015176 |
Show/hide table
| Specification for 347-0968 Crankshaft Gp | |||
| Item | Qty | Part | Specification Description |
| 1 | 2 | 7C-6209 Thrust Plate | Thrust plates should be used only on center main bearing. |
| 2 | 8 | 2W-2288 Plug | Torque to |
| 3 | 32 | 7N-2003 Dowel | Protrusion (B) of the dowel is |
| 4 | 48 | 128-4845 Bolt As | Use the following procedure in order to tighten the bolts:
1. Before assembly, lubricate the bolt threads, the bolt shank, the washer, and the underside of the bolt head with molylube. NOTE: Torque outer bolts first, then torque inner bolt. 2. Tighten the bolts evenly to 3. Again, tighten each bolt for an additional angle of 120 ± 5 degrees. |
| After assembly into cylinder block, end play of the new crankshaft is |
|||
Caterpillar Information System:
3500B and 3500C Marine Engines Cylinder Head Valves
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Cylinder Head Valves
3512C and 3516C Industrial Engines Air Lines
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Site Preparation
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Receiving and Handling
Instructions for Use of Cat Coolant Conditioner for Aluminum Components {1350, 1352, 1395} Instructions for Use of Cat Coolant Conditioner for Aluminum Components {1350, 1352, 1395}
349F and 352F Excavators Radio - If Equipped
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Symbols
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Acronyms
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Serial Number Plate
3516B Generator Set Engines with Dynamic Gas Blending General Information
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
3508C, 3512C and 3516C Locomotive Engines Turbocharger Oil Lines
2012/01/19 Sealing of the Ignition Harness on Certain G3300 and G3400 Engines {1408, 7555}
Product Identification Numbers (PIN) Location Guide Material Handler (Track)
C13 Engine for Combat and Tactical Vehicles Electronic Control Wiring Group
Product Identification Numbers (PIN) Location Guide Material Handler (Wheel)
C13 Engine for Combat and Tactical Vehicles Compression Brake
3516C Locomotive Engines Selective Catalytic Reduction Dosing Lines Blockage - Test
2012/01/16 A New Piston and Rod Group with a One-Piece Piston Is Used in Certain 3512B and 3516B High-Displacement Locomotive Engines {1225}
C15 and C18 Engines for Caterpillar Built Machines Fumes Disposal Filter - Remove and Install
Product Identification Numbers (PIN) Location Guide Backhoe Loader
C15 and C18 Engines for Caterpillar Built Machines Camshaft Gear - Remove and Install
C7.1 Marine Propulsion Engine Overhaul (Major)