Transfer Gear Oil Level - Check
Show/hide table
Illustration 1 | g02756777 |
(1) Oil level port |
Check the oil level of the transfer case under the following conditions:
- The transfer gear and case oil is warmed to operating temperature.
- Run the engine at "LOW" idle.
- The transfer gear is in NEUTRAL.
- The vehicle is on level ground.
- Remove the plug (1) from the oil fill reservoir. The oil level should be to the level of the plug.
- If oil level is below the level of the plug (1), proceed to fill the oil to the correct level.
- Replace the plug (1) into the case.
Caterpillar Information System:
CG137-08 and CG137-12 Engines Exhaust Manifold - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C13, C15, and C18 Tier 4 Final Engines Turbocharger
CG137-08 and CG137-12 Industrial Engines Lubrication System
C13, C15, and C18 Tier 4 Final Engines Turbocharger
C3.4B Engines for Caterpillar Built Machines Compression - Test
349E Excavator Machine System Specifications Auxiliary Hydraulic Lines - Coupler Lines
349E Excavator Machine System Specifications Auxiliary Hydraulic Lines - Coupler Lines
C13, C15, and C18 Tier 4 Final Engines Flywheel
C15 and C18 Engines for Caterpillar Built Machines Engine Trunnion
2011/12/05 A New Valve Assembly is Now Used on Certain Excavators and Mobile Hydraulic Power Units {5057}
2011/07/22 Proper Installation of Exhaust Bellows for C175-16 Generator Set Engines {1059}
349F and 352F Excavators Machine System Specifications Solenoid Valve (System 16, 1-Way, 2-Pump)
3516C Generator Set Engines Engine Speed/Timing Sensor
C13, C15, and C18 Tier 4 Final Engines Cylinder Head
G3600 A4 Engines Engine Speed Sensor
G3516H and G3520H Generator Set Engines Atmospheric Pressure Sensor
C175-16 Locomotive Engine Crankcase Pressure Sensor
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing
C175-16 Locomotive Engine Fuel Pressure Sensor
3512C and 3516C Marine Engines Air Starting Motor
CX28 On-Highway Transmission Transfer Gear Oil - Change
Using the 1U-8860 Large Engine Blowby Pickup Group and the 8T-2700 Blowby/Airflow Indicator{0781, 0785, 1000} Using the 1U-8860 Large Engine Blowby Pickup Group and the 8T-2700 Blowby/Airflow Indicator{0781, 0785, 1000}
2011/08/26 A New Hose Assembly Is Used for the Duplex Fuel Filters on Certain 3500 Engines {1261, 7554}