Engine Crankcase Breather - Clean
Show/hide table
Illustration 1 | g02619151 |
The crankcase breathers are located on the valve covers.
- Remove the tube (1) from the outlet of the breather and loosen the clamp.
- Remove the breather from the engine.
- Check the condition of the seal. Replace the seal if the seal is damaged.
- Remove the breather element. Wash the breather element and wash the breather in a clean nonflammable solvent.
- Shake the breather element until the breather element is dry. You may also use pressurized air in order to dry the breather element.
- Check the condition of the tube. Replace the tube if the tube is damaged.
- Install the element into the breather and install the breather.
- Install the tube onto the outlet of the breather cover and tighten the clamp.
Caterpillar Information System:
C4.4 Generator Sets Electrical System
C15 Generator Sets Fire Prevention and Explosion Prevention
C4.4 Generator Sets Burn Prevention
C15 Generator Sets General Hazard Information
G3304B and G3306B Engines Fan Drive
3406C Industrial Engine Belts - Inspect/Adjust/Replace
C4.4 Generator Sets Battery Information
3516C Generator Sets Product Description
3516C Generator Sets Fluid Recommendations
3512C Oil Well Service Engines Crankshaft Vibration Damper - Inspect
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Cylinder Block
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
Converting the 165-1594 Harness to the 3E-0020 Converter Control Gp {1408, 1926} Converting the 165-1594 Harness to the 3E-0020 Converter Control Gp {1408, 1926}
C15 and C18 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Fuel Transfer Pump
349F and 352F Excavators Machine System Specifications Control Valve (Boom Lowering)
C13, C15, and C18 Tier 4 Final Engines Boost Pressure Sensor
C13, C15, and C18 Tier 4 Final Engines Inlet Manifold Air Pressure Sensor
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Cylinder Head Valves
C13, C15, and C18 Tier 4 Final Engines Inlet Manifold Temperature Sensor
C3.4B Engines For Caterpillar Built Machines Alternator
Retrofitting for Ultra Lean Burn (ULB) on a G3508 Engine{1000, 775E} Retrofitting for Ultra Lean Burn (ULB) on a G3508 Engine{1000, 775E}
C18 Generator Set Alarms and Shutoffs
3516C Generator Sets Engine Oil and Filter - Change