Electronic Control Module (ECM) - Flash Program
Perform the following procedure in order to flash program the ECM. The ECM is flashed in order to upgrade the software. Flash programming of the ECM must also be done if the ECM has been replaced. The Caterpillar Electronic Technician (ET) contains the program WinFlash. WinFlash is used in order to load software into the ECM. The following procedure is used in order to FLASH software into the ECM.
- Procedure
- Connect the data link cable between the communication adapter and the electronic technician.
- Connect the data link cable between the communication adapter and the diagnostic connector of the machine.
- Turn the disconnect switch and the key start switch to the ON position.
- Use WinFlash in order to load the software.
- Cycle the key start switch.
- Clear any active diagnostic codes for the ECM.
- Clear any active diagnostic codes that are associated with the flash program for all other ECM.
- Verify proper operation.
Caterpillar Information System:
Do Not Use Unapproved Connecting Rod 7N-2405 Bolts for 3500 and G3500 Engines{1225, 7553} Do Not Use Unapproved Connecting Rod 7N-2405 Bolts for 3500 and G3500 Engines{1225, 7553}
TA19 Agriculture Transmission Electronic Control System Electrical Connector - Inspect
854K Wheel Dozer and 992K Wheel Loader Power Train Diagnostic Capabilities
TA19 Agriculture Transmission Electronic Control System Determining Diagnostic Trouble Codes
TA19 Agriculture Transmission Electronic Control System Connector Contact Description
CD44B and CD54B Vibratory Asphalt Compactors Turbocharger - Inspect
TA19 Agriculture Transmission Electronic Control System MID 081 - CID 1408 - FMI 05
TA19 Agriculture Transmission Electronic Control System MID 081 - CID 1484 - FMI 07
TA19 Agriculture Transmission Electronic Control System MID 081 - CID 1484 - FMI 02
C15 Petroleum Generator Set Engines Valve Mechanism Cover
2013/03/13 A New Top O-Ring Seal Is Used on the Cylinder Liner in C175-16 and C175-20 Engines {1201, 1216, 7555}
C3.4B Industrial Engine Alternator and Fan Belts - Replace
793F CMD Off-Highway Truck/Tractor Braking System Electronic Control Module (ECM) - Replace
TA19 and TA22 Transmissions Power Train Electronic Control System Inching Pedal - Calibrate
TA19 Agriculture Transmission Electronic Control System Machine Preparation for Troubleshooting
561N, 572R Series II and 572R Pipelayers and D10R, D11R, D5M, D5N, D6M, D6N, D6R, D6R Series II, D7R, D7R Series II and D8R Series II Track-Type Tractors Power Train Electronic Control System Service Tools
TA19 Agriculture Transmission Electronic Control System System Schematic
TA19 and TA22 Transmissions Power Train Electronic Control System Transmission Fill - Calibrate
TA19 and TA22 Transmissions Power Train Electronic Control System Wiring Harness (Open Circuit) - Test
TA19 and TA22 Transmissions Power Train Electronic Control System Wiring Harness (Short Circuit) - Test
TA19 and TA22 Transmissions Power Train Electronic Control System Transmission, SPN 739 - FMI 6
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Wiring
TA19 and TA22 Transmissions Power Train Electronic Control System Transmission, SPN 739 - FMI 5
TA19 and TA22 Transmissions Power Train Electronic Control System Transmission, SPN 1079 - FMI 3