Electric Starting Motor
Show/hide table
Illustration 1 | g02563138 |
Show/hide table
Specification for 350-1614 Electric Starting Motor Gp     | |||
Item     | Qty     | Part     | Specification Description     |
B     | -     | -     | Clearance between the pinion and the housing is 9.1 mm (0.36 inch).     |
1     | 1     | -     | Torque nut to 8.75 ± 1.05 N·m (77.44 ± 9.29 lb in).     |
2     | 2     | -     | Torque stud to 2.25 ± 0.25 N·m (19.91 ± 2.21 lb in).     |
3     | 5     | 6V-8188 Nut     | Torque to 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in).     |
4     | 1     | 4B-2049 Nut     | Torque to 2.6 ± 0.8 N·m (23.0 ± 7.1 lb in).     |
5     | 1     | 4B-2049 Nut     | The switch terminal must be insulated with heat shrinkable tubing. Do not use molded terminals. Torque to 2.6 ± 0.8 N·m (23.0 ± 7.1 lb in).     |
6     | 1     | 6V-8188 Nut     | A maximum of three cable terminals or wire terminals may be used with the battery terminal nut. A maximum of two of the cable terminals may be equal to or greater than 0 AWG. Torque to 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in).     |
-     | -     | -     | Pull-in current at 20 V and 25 °C (77 °F) is 49.3 ± 3.3 Amp.     |
Hold-in current at 20 V and 25 °C (77 °F) is 6.8 Amp max. |
|||
-     | -     | -     | When the electric starting motor is viewed from the pinion end, the motor rotates in the clockwise direction.     |
-     | -     | -     | No load conditions at 25 °C (77 °F):     |
Speed is 6612.0 ± 1887.5 rpm. | |||
Current draw is 100 ± 30 Amp. | |||
Voltage is 23 VDC. |
Caterpillar Information System:
C9.3 Tier 4 Final Engines Valve Mechanism Cover
C15 and C18 Industrial Engines Flywheel
C15 and C18 Industrial Engines Flywheel
3500 Engines Crankcase Breather
CG137-08 and CG137-12 Engines Emergency Stopping
Network Management Card with Modbus for the UPSB505 Uninterruptible Power Supply Web Interface
C9.3 Tier 4 Final Engines Water Lines
XQ400 Power Module Starting the Engine
G3406 Engine Before Starting Engine
C15 Petroleum Generator Set Engines Exhaust Manifold
3500 Engines Crankcase Breather
C175-16 Locomotive Engine Gear Group (Rear)
C13, C15, and C18 Tier 4 Final Engines Flywheel
C13, C15, and C18 Tier 4 Final Engines Camshaft
C15 Petroleum Engines Coolant Temperature Is High
C9.3 Tier 4 Final Engines Main Bearing Journal
C32 Marine and Auxiliary Marine Engines Alternator Mounting
C15 Petroleum Engines Engine Cranks but Does Not Start
C15 Petroleum Engines Engine Top Speed Is Not Obtained
C15 Petroleum Engines Exhaust Temperature Is High
Network Management Card with Modbus for the UPSB505 Uninterruptible Power Supply UPS Monitor and Configure
2011/05/16 Caterpillar Remanufactured Electric Starting Motors Are Improved {1453}
C9.3 Engine for Caterpillar Built Machines Crankshaft
3500C Locomotive Engines Refill Capacities