Piston Cooling Jet
Show/hide table
Illustration 1 | g02490436 |
Typical example |
(1) Tighten the bolt to the following torque. ...
Show/hide table
Illustration 2 | g01352578 |
(2) Piston cooling jet
(3) Rod (4) Cylinder block |
Use the following procedure in order to check the alignment of the piston cooling jet.
- Insert rod (3) into the end of the piston cooling jet (2). Rod (3) has a diameter of
1.70 mm (0.067 inch) . Rod (3) must protrude out of the top of the cylinder block. - Dimension (A) is
50.75 mm (1.9980 inch) and dimension (B) is9.35 mm (0.3681 inch) . Dimension (A) and dimension (B) are tangential to the cylinder bore (4). - The position of the rod (3) must be within dimension (C). Dimension (C) is
14 mm (0.5512 inch) .
Note: Ensure that the rod (3) cannot damage the piston cooling jet when the alignment is checked. The piston cooling jets cannot be adjusted. If a piston cooling jet is not in alignment, the piston cooling jet must be replaced.
Caterpillar Information System:
C3.4B Engines For Caterpillar Built Machines Cylinder Head Valves
C175-16 Locomotive Engine Engine Oil Pump
G3500 A3 Engines Actuator Linkage - Air/Fuel Ratio Control
3500 Generator Sets Coolant Sample (Level 1) - Obtain
UPSB505 Uninterruptible Power Supply Display
UPSB505 Uninterruptible Power Supply Inverter Shutdown
G3500 A3 Engines Throttle Control Linkage
C3.4B Engines For Caterpillar Built Machines Engine Oil Pressure
UPSB505 Uninterruptible Power Supply Temperature Monitor Installation
C3.4B Engines For Caterpillar Built Machines Engine Lifting Bracket
C3.4B Engines For Caterpillar Built Machines Camshaft
C3.4B Engines For Caterpillar Built Machines Cylinder Head
C3.4B Engines For Caterpillar Built Machines Water Pump
C3.4B Engines For Caterpillar Built Machines Water Temperature Regulator and Housing
C3.4B Engines For Caterpillar Built Machines Valve Mechanism Cover
C175-16 Engine for 795F Series AC Off-Highway Trucks Fuel Priming Pump - Electric
C15 Petroleum Engines Speed/Timing - Test
C15 Petroleum Engines Power Take-Off - Test
C15 and C18 Industrial Engines General Information
2011/04/29 New Software With Increased Fuel System Pressure Parameters Is Available for Certain C32 Marine Engines {1901, 1920}
3500 Generator Sets Fluid Recommendations
C9 Industrial Engines Grounding Stud - Inspect/Clean/Tighten
C3.4B Engines for Caterpillar Built Machines Crankshaft Pulley - Check
C3.4B Engines for Caterpillar Built Machines Engine Oil Cooler - Inspect