Electric Starting Motor
Show/hide table
Illustration 1 | g02692756 |
Show/hide table
Illustration 2 | g02692757 |
View A-A |
Show/hide table
Specification for 355-6044 Electric Starting Motor Gp and 353-5055 Electric Starting Motor Gp | |||
Item | Qty | Part | Specification Description |
When the electric starting motor is viewed from the pinion end, the motor rotates in Clockwise direction. | |||
1 | 1 | 338-3453 Starting Motor Solenoid | Current consumption at 20V and Pull-in winding is 49.3 ± 3.3 Amp. Hold-in winding is 6.8 Amp max. |
2 | - | - | Torque to |
3 | 2 | 6V-8188 Nut | Torque the ground terminal nut to |
B | - | - | Clearance between the pinion and the housing is |
4 | 2 | - | Torque the start relay terminal nut to |
5 | 2 | 4B-2049 Nut | The switch terminal must be insulated with heat shrink tubing. Do not use molded terminals. |
Torque to |
|||
6 | 1 | 6V-8188 Nut | Torque the motor terminal nut to |
7 | 1 | 6V-8188 Nut | A maximum of three cable terminals or wire terminals may be used between the battery terminal nut (5). A maximum of two of the cable terminals may be equal to or greater than 0 AWG. |
Torque the battery terminal nut to |
|||
8 | 2 | 6V-8188 Nut | Torque the motor frame terminal nut to |
- | - | - | No load conditions at Speed is 6612.0 ± 1887.5 rpm. Current draw is 100 ± 30 Amp. Voltage is 23 VDC. |
Caterpillar Information System:
G3500 A3 Engines Coolant Pressure Is Low
G3500 A3 Engines Coolant Pressure Is High
320 VH and VM Variable Gauge Undercarriage Track Carrier Roller - Remove and Install - VM Undercarriage
C27 and C32 Industrial Engines Rear Power Take-Off (RPTO) - Install
C175-16 Locomotive Engine Engine Oil Pressure - Test
C3.4B Engines Cylinder Is Noisy
C3.4B Engines Coolant Temperature Is High
2010/10/20 A New Camshaft Thrust Washer and Plate Are Used in C175-16 Generator Set Engines {1210, 1210, 7553}
C3.4B Engines Coolant Contains Oil
C3.4B Engines Battery Problem
C3.4B Engines Alternator Problem - Charging Problem and/or Noisy Operation
C6.6 Industrial Engine Flywheel Housing - Flywheel Housing that is Equipped with Rear Power Take-Off
C3.4B Engines Electronic Service Tool Does Not Communicate
C3.4B Engines Engine Does Not Crank
C3.4B Engines Engine Has Mechanical Noise (Knock)
C3.4B Engines Engine Shutdown Occurs Intermittently
C6.6 Industrial Engine Exhaust Cooler (NRS) - Test
C9.3 Tier 4 Final Engines Pressure Sensor (NOx Reduction System)
C18 Generator Set Engines Secondary ECM Assumes Control
C9.3 Tier 4 Final Engines Temperature Sensor (NOx Reduction System)
G3304B and G3306B Engines Air/Fuel Ratio Control - Adjust
2011/03/02 A New Filter Connector is Added to the Pilot Hydraulic System on Certain Excavators {5264}
C15 and C18 Engines Severe Service Application
C27 and C32 Industrial Engines Cylinder Head - Remove