Fuel Transfer Pump - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the fuel supply to the Off position.
Show/hide table
Illustration 1 g02260336 - Remove two nuts and remove bracket assembly (1).
- Remove clamp assembly (3) and position tube assembly (2) out of the way.
Show/hide table
Illustration 2 g02260413 - Disconnect fitting (8). Loosen clamp assembly (4) and remove tube assembly (5).
- Remove clamp assembly (6). Disconnect hose assembly (7) and position the hose assembly out of the way.
Show/hide table
Illustration 3 g02260433 - Remove bolts (9) and remove the fuel transfer pump (10). Remove the O-ring seal from the fuel transfer pump (not shown).
Show/hide table
Illustration 4 g02260474 Show/hide tablePersonal injury can result from parts and/or covers under spring pressure.
Spring force will be released when covers are removed.
Be prepared to hold spring loaded covers as the bolts are loosened.
- Remove plug (11) and remove the spring (12) (not shown). Remove the O-ring seal that is located on plug (11).
- Install the fuel transfer pump (10) in the reverse order.
- Tighten clamp assembly (3) to a torque of
8.5 ± 2 N·m (75 ± 18 lb in) .
- Tighten clamp assembly (3) to a torque of
Caterpillar Information System:
C27 Petroleum Engine Fuel Pressure Sensor - Remove and Install - Filter Bypass
C7.1 (Mech) Industrial Engine Vibration Damper - Check
C27 and C32 Industrial Engines Fuel Temperature Sensor - Remove and Install
C27 and C32 Industrial Engines Fuel Pressure Sensor - Remove and Install
3512C HD Locomotive Engine Plate Locations and Film Locations
C27 and C32 Engines for Caterpillar Built Machines Engine Control Module - Remove and Install
349F and 352F Excavators System Pressure Release
320E and 323E Excavators Swing Bearing - Lubricate
3516B HD Generator Set Engine Oil and Filter - Change
C13 Tier 4 Final Engines Fuel Pressure Regulator
C15 Petroleum Generator Set Engines Piston and Rings
C7.1 Engines for Caterpillar Built Machines Connecting Rod - Inspect
C27 and C32 Industrial Engines Fuel Pressure Regulator - Remove and Install
3512C HD Locomotive Engine Engine Electronics
C27 Generator Set Engines Magnetic Pickup
3512C HD Locomotive Engine Gauges and Indicators
3512C HD Locomotive Engine Cooling System Coolant Sample (Level 1) - Obtain
C27 and C32 Engines for Caterpillar Built Machines Water Pump - Remove and Install
320E and 323E Excavators Stopping the Engine
3512C HD Locomotive Engine Engine Oil Sample - Obtain
C27 and C32 Industrial Engines Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Industrial Engines Electrical System
C6.6 Industrial Engine Engine Oil Filter Base - Remove and Install - Engine Oil Filter Base with Adapter
C4.4 Industrial Engine Accessory Drive - Remove and Install - Accessory Drive SAE "B"