Solenoid Valve (ARD Main Fuel) - Remove and Install
Removal Procedure
- Remove nut (6), washer (5), and solenoid (4) from valve assembly (1) .
Show/hide table
Illustration 1 | g02205415 |
The fuel manifold is located on the Clean Emissions Manual. |
Show/hide table
Illustration 2 | g02205416 |
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This action will help to prevent dirt from entering the internal mechanism.
- Remove cartridge assembly (3) and remove O-ring seals (2) .
Installation Procedure
- Install the solenoid valve (ARD main fuel) in the reverse order of removal.
- Tighten cartridge assembly (3) to a torque of 50 ± 5 N·m (37 ± 4 lb ft).
- Tighten the nut (6) to a torque of 20 ± 2.5 N·m (177 ± 22 lb in).
Caterpillar Information System:
C15 and C18 Industrial Engines Soot Sensor - Remove and Install
C15 and C18 Industrial Engines Soot Antenna - Remove and Install - Clean Emissions Module
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package ARD Spark Plug - Replace
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package Belts - Inspect/Adjust/Replace
C15 and C18 Industrial Engines Pressure Sensor (ARD Combustion Air) - Remove and Install
C15 and C18 Industrial Engines Electronic Control (ARD Combustion Air) - Remove and Install
3512C Oil Well Service Engines Belts - Inspect/Adjust/Replace
EMCP4.3/4.4 Generator Circuit Breaker Operation Failure
EMCP4.3/4.4 Load Sharing Input Circuit Fault
EMCP4.3/4.4 Synchronization Failure
C15 and C18 Industrial Engines Ignition Coil - Remove and Install - Clean Emissions Module
C7.1 Industrial Engine and Generator Set Diesel Particulate Filter Requires Initial Regeneration
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Safety Messages
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package Fuel System Primary Filter (Water Separator) Element - Replace
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators General Information
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Display Description
C27 and C32 Engines for Caterpillar Built Machines Water Pump - Disassemble
C27 and C32 Engines for Caterpillar Built Machines Water Pump - Assemble
584 and 584HD Forwarders Fire Safety
C27 and C32 Industrial Engines Flywheel - Remove and Install
C7.1 Industrial Engine Flow Control Valve - Remove and Install
C7.1 Industrial Engine Fuel Temperature Sensor - Remove and Install
Incorrectly Assembled 0R-8320 Cylinder Pack As from the Factory for 3406C Truck Engines{1225, 1239} Incorrectly Assembled 0R-8320 Cylinder Pack As from the Factory for 3406C Truck Engines{1225, 1239}
NEHS1032: 538-5051 Communications Adapter 3 {0599, 0709, 1900, 4800, 7490, 7600} NEHS1032: 538-5051 Communications Adapter 3 {0599, 0709, 1900, 4800, 7490, 7600}