Soot Sensor - Remove and Install
拆卸步骤
- 将两个线束组件 (1) 从烟尘天线上拆下。
Show/hide table
图 1 | g02205113 |
注: 确保烟尘天线和线束组件接头清洁无异物。 为了防止异物进入接头,务必利用塞子或保护盖封堵接头。
- 拆下环形夹 (2) 。
- 断开线束组件 (4) 。 拆下螺栓后拆下烟尘传感器 (3) 。
安装步骤
- 按相反顺序安装烟尘传感器。
- 安装线束组件 (1) 时,保持最小 51 mm (2 in) 的弯曲直径。
Show/hide table图 2 g02205253
- 用手拧紧线束组件 (1) 。
注: 确保烟尘天线和线束组件接头清洁无异物。
Caterpillar Information System:
C15 and C18 Industrial Engines Soot Antenna - Remove and Install - Clean Emissions Module
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package ARD Spark Plug - Replace
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package Belts - Inspect/Adjust/Replace
C15 and C18 Industrial Engines Pressure Sensor (ARD Combustion Air) - Remove and Install
C15 and C18 Industrial Engines Electronic Control (ARD Combustion Air) - Remove and Install
3512C Oil Well Service Engines Belts - Inspect/Adjust/Replace
EMCP4.3/4.4 Generator Circuit Breaker Operation Failure
EMCP4.3/4.4 Load Sharing Input Circuit Fault
EMCP4.3/4.4 Synchronization Failure
C15 and C18 Industrial Engines Ignition Coil - Remove and Install - Clean Emissions Module
C7.1 Industrial Engine and Generator Set Diesel Particulate Filter Requires Initial Regeneration
2010/10/18 New High Pressure Fuel Pump and Adapter for C175 Generator Sets {1251, 1290}
C15 and C18 Industrial Engines Solenoid Valve (ARD Main Fuel) - Remove and Install
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Safety Messages
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package Fuel System Primary Filter (Water Separator) Element - Replace
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators General Information
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Display Description
C27 and C32 Engines for Caterpillar Built Machines Water Pump - Disassemble
C27 and C32 Engines for Caterpillar Built Machines Water Pump - Assemble
584 and 584HD Forwarders Fire Safety
C27 and C32 Industrial Engines Flywheel - Remove and Install
C7.1 Industrial Engine Flow Control Valve - Remove and Install
C7.1 Industrial Engine Fuel Temperature Sensor - Remove and Install
Incorrectly Assembled 0R-8320 Cylinder Pack As from the Factory for 3406C Truck Engines{1225, 1239} Incorrectly Assembled 0R-8320 Cylinder Pack As from the Factory for 3406C Truck Engines{1225, 1239}