Soot Antenna - Remove and Install - Clean Emissions Module
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | −     | Loctite 771     | −     |
- 将线束组件 (2) 从烟尘天线 (1) 上断开。
Show/hide table
图 1 | g02204834 |
典型示例 |
注: 确保烟尘天线和线束组件接头清洁无异物。 为了防止异物进入接头,断开时,务必利用塞子或保护盖封堵接头。
- 将烟尘天线 (1) 从清洁排放模块上拆下。
安装步骤
- 按相反顺序安装烟尘天线 (1) 。
- 将工具 (A) 涂抹到烟尘天线 (1) 的螺纹上。 将烟尘天线 (1) 上紧到 45 ± 5 N·m (33 ± 4 lb ft) 的扭矩。
- 连接到烟尘天线 (2) 上时,用手带紧线束组件 (2) 。
注: 确保烟尘天线和线束组件接头清洁无异物。
Caterpillar Information System:
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package ARD Spark Plug - Replace
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package Belts - Inspect/Adjust/Replace
C15 and C18 Industrial Engines Pressure Sensor (ARD Combustion Air) - Remove and Install
C15 and C18 Industrial Engines Electronic Control (ARD Combustion Air) - Remove and Install
3512C Oil Well Service Engines Belts - Inspect/Adjust/Replace
EMCP4.3/4.4 Generator Circuit Breaker Operation Failure
EMCP4.3/4.4 Load Sharing Input Circuit Fault
EMCP4.3/4.4 Synchronization Failure
C15 and C18 Industrial Engines Ignition Coil - Remove and Install - Clean Emissions Module
C7.1 Industrial Engine and Generator Set Diesel Particulate Filter Requires Initial Regeneration
2010/10/18 New High Pressure Fuel Pump and Adapter for C175 Generator Sets {1251, 1290}
390F Excavator Machine System Bucket Linkage
C15 and C18 Industrial Engines Soot Sensor - Remove and Install
C15 and C18 Industrial Engines Solenoid Valve (ARD Main Fuel) - Remove and Install
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Safety Messages
C9.3 Industrial Engine and CX31-P600-C9I Petroleum Power Train Package Fuel System Primary Filter (Water Separator) Element - Replace
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators General Information
Cat® Grade Control Depth & Slope for E-Series and F-Series Excavators Display Description
C27 and C32 Engines for Caterpillar Built Machines Water Pump - Disassemble
C27 and C32 Engines for Caterpillar Built Machines Water Pump - Assemble
584 and 584HD Forwarders Fire Safety
C27 and C32 Industrial Engines Flywheel - Remove and Install
C7.1 Industrial Engine Flow Control Valve - Remove and Install
C7.1 Industrial Engine Fuel Temperature Sensor - Remove and Install