Pump Drive Shaft (Hydraulic) - Remove and Install
拆卸步骤
Show/hide table
车斗降下后,车斗与机架之间没有空隙。 如果不安装固定缆线,可能会导致在此区域作业的人员受伤或死亡。 |
- 安装车斗固定拉线。 操作和保养手册, "拉线(车斗固定)"。
- 拆下驱动轴护罩 (1) 。
Show/hide table
图 1 | g02163473 |
- 使用适当的起吊设备以支撑驱动轴 (2) 的重量。 传动轴 (2) 的重量约为 25 kg (55 lb)。
Show/hide table
图 2 | g02163482 |
- 拆下螺栓 (3 ) 。 对另一面重复此步骤。
Show/hide table
图 3 | g02163485 |
- 需要两个人和适当的起吊设备,以便拆下传动轴 (2) 。
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 按相反顺序安装驱动轴 (2) 。
- 拧紧螺栓 (3) 至扭矩为 135 ± 20 N·m (100 ± 15 lb ft)。
注: 按照 "X" 交叉方式,拧紧螺栓 (3) 。
- 拧紧螺栓 (3) 至扭矩为 135 ± 20 N·m (100 ± 15 lb ft)。
Caterpillar Information System:
374F Excavator Hydraulic System Filter Element (Fine Filtration) - Replace - If Equipped
C27 and C32 Generator Set Engines Cylinder Block
2010/06/04 Starting Instructions and Diagnostic Procedure for Certain C7 Engines That Are Used in RoadTec Pavers {1000}
C4.4 Industrial Engine Belt - Inspect
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Turbocharger - Inspect
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fumes Disposal Filter Element - Replace - Open Crankcase Ventilation (OCV) Filter
797F and 797F XQ Off-Highway Trucks Machine Systems Steering Column - Remove and Install
C175-16 Engine Overhaul (Major)
C175-16 Engine Overhaul (Top End)
C175-16 Engine Overhaul (In-Frame)
Installation and Initial Start-Up Procedure for G3512B ULB Engine{1000} Installation and Initial Start-Up Procedure for G3512B ULB Engine{1000}
325 VM and VH Variable Gauge Undercarriage Travel Motor - Remove and Install - VM Undercarriage
C175-16 Generator Set Engine Oil and Filter - Change
797F and 797F XQ Off-Highway Trucks Machine Systems Lubrication Pump (Automatic) - Remove and Install
2010/06/15 An Improved Piston Is used on 3500 Remanufactured Engines {1225}
2010/06/25 Improved Piston used on 3500 Remanufactured Engines {1225}
320 VH and VM Variable Gauge Undercarriage Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove and Install
320 VH and VM Variable Gauge Undercarriage Recoil Spring - Disassemble
320 VH and VM Variable Gauge Undercarriage Recoil Spring - Assemble
C4.4 (Mech) Marine Generator Set MCS-3 Engine Crankcase Breather - Replace - Turbocharged Engines and Naturally Aspirated Engines
797F and 797F XQ Off-Highway Trucks Machine Systems Blower Motor (Air Conditioner and Heater) - Remove and Install
C4.4 (Mech) Marine Generator Set MCS-3 Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
797F and 797F XQ Off-Highway Trucks Machine Systems Relay Valve (Air Start) - Remove and Install
C4.4 (Mech) Marine Generator Set MCS-3 Auxiliary Water Pump - Inspect - Bronze Auxiliary Water Pump