Engine Crankcase Breather - Replace - Turbocharged Engines and Naturally Aspirated Engines
注: 涡轮增压发动机上的曲轴箱通风器滤清器的壳体也必须更换。 有关正确步骤,请参阅操作和保养手册, "发动机曲轴箱通气孔 - 更换(涡轮增压发动机)"。
Show/hide table
图 1 | g02163655 |
典型示例 |
- 卸下防尘盖 (1)。
- 卸下螺钉 (2) 和盖 (3)。
- 拆卸罩盖 (4) 和弹簧 (5)。 卸下罩盖 (4) 和弹簧 (5)。
- 安装新罩盖 (4) 和新弹簧 (5)。
- 安装盖 (3) 和螺钉 (2)。 将螺钉 (2) 拧紧到扭矩
1.3 N·m (11.5 lb in) 。 - 安装防尘盖 (1)。
Caterpillar Information System:
320 VH and VM Variable Gauge Undercarriage Recoil Spring - Assemble
320 VH and VM Variable Gauge Undercarriage Recoil Spring - Disassemble
320 VH and VM Variable Gauge Undercarriage Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove and Install
2010/06/25 Improved Piston used on 3500 Remanufactured Engines {1225}
2010/06/15 An Improved Piston Is used on 3500 Remanufactured Engines {1225}
797F and 797F XQ Off-Highway Trucks Machine Systems Lubrication Pump (Automatic) - Remove and Install
C175-16 Generator Set Engine Oil and Filter - Change
797F and 797F XQ Off-Highway Trucks Machine Systems Pump Drive Shaft (Hydraulic) - Remove and Install
374F Excavator Hydraulic System Filter Element (Fine Filtration) - Replace - If Equipped
C27 and C32 Generator Set Engines Cylinder Block
2010/06/04 Starting Instructions and Diagnostic Procedure for Certain C7 Engines That Are Used in RoadTec Pavers {1000}
C4.4 Industrial Engine Belt - Inspect
797F and 797F XQ Off-Highway Trucks Machine Systems Blower Motor (Air Conditioner and Heater) - Remove and Install
C4.4 (Mech) Marine Generator Set MCS-3 Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
797F and 797F XQ Off-Highway Trucks Machine Systems Relay Valve (Air Start) - Remove and Install
C4.4 (Mech) Marine Generator Set MCS-3 Auxiliary Water Pump - Inspect - Bronze Auxiliary Water Pump
797F and 797F XQ Off-Highway Trucks Machine Systems Solenoid Valve (Air Start) - Remove and Install
797F and 797F XQ Off-Highway Trucks Machine Systems Center Arm (Steering) - Remove and Install
C27 Generator Set Engines Configuration Parameters
C9.3 Engines for Caterpillar Built Machines Unit Injector Sleeve - Remove
C13, C15, and C18 Tier 4 Interim Engines Fuel System Water Separator Has Water
C9.3 Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
320 VH and VM Variable Gauge Undercarriage Sprocket - Remove and Install
320 VH and VM Variable Gauge Undercarriage Track Roller - Remove and Install - VH Undercarriage