Vibration Damper and Pulley
Show/hide table
| |
| Illustration 1 | g02153930 |
|
Typical example | |
(1) Tighten the setscrews for the adapter to the following torque. ...
The setscrews (1) must be tightened through an angle of 120 degrees.
(2) Tighten the bolts for the damper and pulley to the following torque. ...
(3) Vibration damper
(4) Crankshaft pulley
(5) Crankshaft adapter
Caterpillar Information System:
C11 and C13 Engines Fuel Injector
2010/07/30 New Cage Assembly Is Used on TH48-E80 Petroleum Transmissions {3160}
2010/05/19 An Improved Water Line Is Now Used on Certain Commercial Engines {1355, 1380, 1393}
C13, C15, and C18 Tier 4 Final Engines Inlet Manifold Air Pressure Sensor
C15 and C18 Engines for Caterpillar Built Machines Fan Drive
C15 and C18 Engines Fuel Priming Pump - Replace
320E and 323E Excavators Cooling System Coolant Level - Check
320E and 323E Excavators Cooling System Coolant Extender (ELC) - Add
C4.4 Industrial Engine Turbocharger - Series Turbochargers
C11 and C13 Engines Muffler
C4.4 Industrial Engine Turbocharger - Single Turbocharger
C4.4 Industrial Engine Temperature Sensor (NOx Reduction System)
C9.3 Engines for Caterpillar Built Machines Electrical Connectors
C6.6 Industrial Engine Vibration Damper - Check
C15 and C18 Tier 4 Final Engines ARD Fuel System - Test
Reuse Guideline for the Flexible Exhaust Pipe Group on Tier 4 Engines {1061} Reuse Guideline for the Flexible Exhaust Pipe Group on Tier 4 Engines {1061}
C6.6 Industrial Engine Product Lifting - Engine
C7.1 Industrial Engine Product Lifting - Clean Emission Module
2010/05/13 New Flash File for Certain C6.6 Engines {1901, 1920}
325 VM and VH Variable Gauge Undercarriage Track Roller - Remove and Install
325 VM and VH Variable Gauge Undercarriage Sprocket - Remove and Install
Reuse and Salvage for Flywheel Assemblies {1156} Reuse and Salvage for Flywheel Assemblies {1156}
C7.1 Industrial Engine Air Control Valve - Remove and Install - Clean Emissions Module
C7.1 Industrial Engine Alternator - Install