C4.4 (Mech) Marine Generator Set MCS-3 Caterpillar


Battery Electrolyte Level - Check

Usage:

C4.4 L1K
当发动机长时间不运转或只是短时间运转时,蓄电池可能未充足电。 确保蓄电池充足电以防止蓄电池结冻。 如果蓄电池充电得当,发动机运转时,电表读数应非常接近零。

------ WARNING! ------

所有铅酸蓄电池含有硫酸,硫酸能烧蚀皮肤和腐蚀衣服。 对蓄电池作业或在其附近工作时,必须戴防护面罩和穿防护服。


  1. 拆下加注口盖。 蓄电池的电解液位保持在蓄电池的 "满 (FULL)"标记位置。

    如果需要加水,应使用蒸馏水。 如果没有蒸馏水,可使用低矿物质的清水。 不要使用人工软化水。

  2. 使用 245-5829 冷却液蓄电池测试折光仪来检查电解液的状况。

  3. 保持蓄电池清洁。

    用以下清洁剂清洗蓄电池壳:

    • 使用 0.1 kg (0.2 lb) 碳酸氢钠与 1 L (1 qt) 清水的溶液。

    • 使用氢氧化铵溶液。

    用清洁水彻底冲洗蓄电池壳。

    用细砂纸清洁端子和电缆卡箍。 直到其表面光亮为止。 不要过度去除材料。 过分地去除材料可能会造成卡箍无法完全密接。 在卡箍和端子上涂抹 5N-5561 硅树脂润滑剂 、石油冻或MPGM。

Caterpillar Information System:

C4.4 (Mech) Marine Generator Set MCS-3 Battery Charger - Check
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Engine Rating Definitions
C4.4 (Mech) Marine Generator Set MCS-3 Battery - Replace
C4.4 (Mech) Marine Generator Set MCS-3 Auxiliary Water Pump - Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Automatic Start/Stop - Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Alternator - Inspect
Replacement of Horn On Certain EMCP 3 Control Panels On Certain Generator Sets{4490, 7402} Replacement of Horn On Certain EMCP 3 Control Panels On Certain Generator Sets{4490, 7402}
C4.4 (Mech) Marine Generator Set MCS-3 Diagnostic Lamp
C4.4 (Mech) Marine Generator Set MCS-3 Refill Capacities and Recommendations
C4.4 (Mech) Marine Generator Set MCS-3 System Pressure Release
C13, C15, and C18 Tier 4 Interim Engines Sensor Signal (Analog, Passive) - Test
C4.4 (Mech) Marine Generator Set MCS-3 Control Panel
C4.4 (Mech) Marine Generator Set MCS-3 Battery or Battery Cable - Disconnect
2010/04/15 A New Torque Is Used for Installing the Check Valve Gp into the Secondary Fuel Filter Base on Certain Machine Engines {1261, 1274, 5067}
C4.4 (Mech) Marine Generator Set MCS-3 Belts - Inspect/Adjust/Replace - Single Belt
2010/04/16 A New Torque Is Used for Installing the Check Valve Gp into the Secondary Fuel Filter Base on Certain Commercial Engines {1261, 1274, 5067}
2010/04/15 A New Torque Is Used for Installing the Check Valve Gp into the Secondary Fuel Filter Base on Certain Truck Engines {1261, 1274, 5067}
349F and 352F Excavators Hydraulic System Main Pump (Flow) - Test - Constant Horsepower Flow Control
797F and 797 XQ Off-Highway Trucks Engine Supplement Refrigerant Condenser - Remove and Install
C11, C13, C15, and C18 Industrial Engines Engine Overcrank Occurrence
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel System Secondary Filter - Replace
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel System Primary Filter (Water Separator) Element - Replace
C9.3 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
C4.4 (Mech) Marine Generator Set MCS-3 Reference Information
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.