Crankshaft
Show/hide table
图 1 | g02066516 |
(1) 主轴承轴颈
(2) 连杆轴承轴颈 |
止推板只可用于中间主轴承轴颈上。
(A) 曲轴齿轮的尺寸
- 组装后的平均直径 ...
136.20 ± 0.11 mm (5.362 ± 0.004 in) - 组装后的最大直径 ...
136.36 mm (5.368 in) - 组装后的最大直径 ...
(C) 定位销 (3) 上部与曲轴表面之间的高度 ...
注: 曲轴组装到缸体后,曲轴轴向间隙最大应为
注: 曲轴齿轮和曲轴之间的间隙不应超过
Caterpillar Information System:
C9.3 Tier 4 Interim Engines Configuration Parameters
349F and 352F Excavators Machine System Cylinders (Boom, Stick and Bucket)
C27 and C32 Generator Set Engines Fuel Transfer Pump
Hydraulic Excavator Roller Disassembly and Assembly Procedures {0729, 0768, 4154, 4180, 4181} Hydraulic Excavator Roller Disassembly and Assembly Procedures {0729, 0768, 4154, 4180, 4181}
C13, C15, and C18 Tier 4 Final Engines Cylinder Block
C13, C15, and C18 Tier 4 Final Engines Cylinder Block
2009/12/24 Normal Wear on the Cylinder Liners of Some C11 and C13 Engines {1201}
G3500 Engines Model View Illustrations
3412E and C30 Marine Engines Maintenance Interval Schedule - Fast Craft
3412E and C30 Marine Engines Maintenance Interval Schedule - Standard
C9.3 Tier 4 Final Engines Crankshaft Pulley
C13 Industrial Engines Water Pump
C27 and C32 Tier 4 Engines Water Pump - Test
Roller Service Evaluation Checklist {4154, 4180, 4181, 7561} Roller Service Evaluation Checklist {4154, 4180, 4181, 7561}
C13, C15, and C18 Tier 4 Final Engines Exhaust Manifold
C13, C15, and C18 Tier 4 Final Engines Exhaust Lines (DPF Inlet)
C27 and C32 Engines for Caterpillar Built Machines Exhaust Temperature Is High
C4.4 Industrial Engine High Pressure Fuel Lines
Guidelines for Routing and Installing Wire Harness Assemblies {1408, 7553} Guidelines for Routing and Installing Wire Harness Assemblies {1408, 7553}
C4.4 Industrial Engine Electrical System
C6.6 Marine Generator Set ECM Memory - Test
C15 and C18 Engines for Caterpillar Built Machines Speed Control - Test
C175-16 PETROLEUM ENGINES Engine Oil and Water Pump Drive - Disassemble
C175-16 PETROLEUM ENGINES Engine Oil and Water Pump Drive - Assemble