6V2042 Alignment Yoke And 6V2043 Alignment Bar Available{0653,3305,4450}
Usage:
All Marine Transmissions And All Generator Sets
The 6V2042 Alignment Yoke and 6V2043 Alignment Bar are available to check the alignment of the marine transmission output shaft to the propeller shaft and the alignment of the engine to the generator. The new tools are used instead of the former FT1010 Alignment Yoke and FT1011 Alignment Bar which had to be fabricated. The former tools are canceled.
Caterpillar Information System:
1979/09/17 New Bracket Available For Installation Of Jacket Water Heater{1383}
1979/09/17 Improved Sea Water Pump Now Used{1361,1371}
1979/09/17 Raw Water Pump Improved{1371}
1979/09/17 Keystone Piston Groups Can Be Installed In Earlier Engines In Steiger Tractors{1214,1215}
1979/09/17 New BrakeSaver Control Valve Group Has Improved Diaphragm{1159,1155}
1979/09/17 New Main And Connecting Rod Bearings Have A Thicker Layer Of Surface Material{1230,1203,1219}
1979/09/10 Engines Can Use Crankshafts With Either Six Or Eight Counterweights {1202}
1979/09/10 Pin Bore Is Now Offset (Not In The Center) .059" (1.5 mm) In The Piston To Stop Vibration Of The Cylinder Liners Which Can Cause Pitting On The Coolant Side Of The Cylinder Liners {1214,1216}
1979/09/10 Tee Handle Hexagonal Wrench In Rack Adjusting Tool Is Now Available For Parts Replacement
1979/09/10 Recommendation For Use Of A FLEX-HONE On 1100, 3100 and 3200 Series Engines {1201}
1979/09/10 Different Grease Fitting Now Used In Fan Drive Group {1359}
1979/09/10 New Gasket Used In Water Lines Group For Aftercooler {1380,1063}
1979/09/24 8S9901 Tool Cart Can Be Adapted To Hold Both The 5P3600 Hydraulic Flow Meter Group And The Tools Used With It{0651}
1979/09/24 Cranking Speeds Necessary To Start Diesel Engines{0374,1000,1450}
1979/10/01 New Liner Seat Inserts For Spacer Plate Cylinder Blocks Are Made Of Stainless Steel{1217,1201,0663}
1979/10/01 Steel Plates Are Now Used To Hold The Element In Position In The Panel-Type Air Cleaner Housing Assembly{1051,1054}
1979/10/01 Tips For SIRS (Service Information Retrieval System) Users{0374}
1979/10/01 New Aftercooler Core Has Stronger Construction And Corrosion Resistance{1064}
1979/10/01 New Planet Gears For Power Shift Transmissions And/Or Winches Have No Oil Grooves On the Faces{3176,5165}
1979/10/08 Warning: Excessive Heat Can Cause A Tire Explosion{4203}
1979/10/08 Fast Fuel Delivery Couplings And Fast Oil Change Couplings Are Available For All Caterpillar Equipment{0671,1273,1279,1325}
1979/10/08 New Hydromechanical Shut-Off Is Available{7418,7403}
1979/10/08 Supplement To Special Instruction, Form SEHS6895, "Bench Testing Hydraulic Components" Now Available On Microfiche{0650}
1979/10/15 Engine Oil Viscosity Changed To SAE 10W/30 For Shipment From All U.S. Factories{1318}