6V183 Gasket Now Available For Parts Service To Use On 5P4150 Or 8S2242 Nozzle Tester{0651}
Usage:
Caterpillar Information System:
1979/06/25 Use Of 9S3265 Retaining Compound On Schwitzer Turbocharger Compressor Wheel Retainer Nuts{1052,1053}
1979/06/25 6V117 And 6V2001 Bushings Used In 9S8140 Pressurizing Pump Group Are Available For Parts Service{0651}
1979/06/18 Shorter Bolt Used In BrakeSaver Manifold To Prevent Possible Contact With Bolt In Transmission{1155,1013}
1979/06/18 During Installation Of An Auxiliary Bypass Oil Filter, Be Sure Passage In Oil Cooler Fitting Is Open{1314,1378}
1979/06/18 Temperature Compensator Conversion Group Available For Fuel System To Prevent Low Power Output{1250}
1979/06/11 Test Specifications Now Available For 9N3979 And 9N2366 Pencil Type Fuel Nozzle Assemblies{0652,1254}
1979/06/11 New Specification For Installation Of Camshaft Front Bearing In Cylinder Block{1211}
1979/06/04 New Centering Rings For Oversized Main Bearings{0665,1230}
1979/06/04 Check Crankshaft Seals During Installation Of Engine Overhaul Gasket Kits; Add A Wear Sleeve When Needed{7555,7558,1161}
1979/06/04 New Caterpillar Yellow Paint{0670}
1979/06/04 New "L-Shaped" Clutch Plates Now Used{3302}
1979/05/28 Correct Locations To Connect Gauges For Checks Of Engine Oil Temperature And/Or Pressure{7455,7450,1300}
1979/06/25 New Water Pump Assemblies Use An Improved Seal Assembly{1361}
1979/06/25 Engine Front Support Now Machined To Prevent Possible Failure Of The Support Brackets For the Power Takeoff{1153,3055}
1979/06/25 New Air Inlet Tube Gives Enough Room To Install A "Jake Brake"{1058,1119}
1979/06/25 6V2010 Polishing Stone Available{0622}
1979/07/02 To Prevent A Possible Change In The Fuel Rack Setting, A Specific Assembly Procedure Must Be Used To Tighten The Bolt On The Governor Stop Collar{1259,1257,1250}
1979/07/02 6V109 Torque Multiplier Available For Use With Hydraulic Cylinder Repair Stand{0614}
1979/07/02 Improved Engine Design Uses Cylinder Block With Spacer Plate And New Crankshaft Thrust Plates{1000}
1979/07/02 Fuel Injection Line For Injection Test Bench Is Available From Caterpillar{0652,1250}
1979/07/09 Caution Label Added To 5P4150 Nozzle Testing Group{0651}
1979/07/09 New Valve Cover Gasket Has Better Material{1107}
1979/07/09 New Shaft Assembly Used In Governor Group And New Coupling Assembly Used In Drive Group For Governor And Fuel Injection Pump{1264,1288}
1979/07/09 New Cylinder Liner Has Improved Design To Keep Liner Temperatures Lower{1216}