Temperature Sensor (DPF) - Remove and Install - Clean Emissions Module
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 4C-5597 | Anti-Seize Compound | - |
- Remove cable straps (2) and remove flame detection sensor (1).
Show/hide table
Illustration 2 g02331096 - Remove cable straps (5). Disconnect harness assembly (4) from temperature sensor (3).
Show/hide table
Illustration 3 g02331117 - Remove cable straps (6) and remove temperature sensor (7).
Show/hide table
| |
| Illustration 1 | g02329135 |
- Install the temperature sensor in reverse order.
- Apply Tooling (A) to the threads of flame detection temperature sensor (1) and temperature sensor (7). Tighten the sensors to a torque of
45 ± 5 N·m (33 ± 4 lb ft) .
- Apply Tooling (A) to the threads of flame detection temperature sensor (1) and temperature sensor (7). Tighten the sensors to a torque of
Caterpillar Information System:
C7.1 Industrial Engine and Generator Set Indicator Lamp Circuit - Test
C13 Engines for Caterpillar Built Machines Catalyst - Remove and Install - Diesel Oxidation Catalyst, Clean Emissions Module
C7.1 Industrial Engine and Generator Set Idle Validation Switch Circuit - Test
C13 Engines for Caterpillar Built Machines Diesel Particulate Filter - Remove and Install - Clean Emissions Module
C13 Engines for Caterpillar Built Machines Soot Antenna - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor
C13, C15, and C18 Tier 4 Final Engines Boost Pressure Sensor
C13 Engines for Caterpillar Built Machines Flame Detection Temperature Sensor - Remove and Install - Clean Emissions Module
C18 Marine Engines Engine Speed/Timing Sensor - Clean/Inspect
C32 Marine Engine Pinion Clearance - Adjust
C7.1 Industrial Engine and Generator Set Ignition Keyswitch Circuit and Battery Supply Circuit - Test
C7.1 Industrial Engine and Generator Set Engine Pressure Sensor Open or Short Circuit - Test
C9.3 Industrial Engine Air Compressor
Oversized Injector Sleeves for Remanufactured Cylinder Heads On Medium Sized Engines{1100, 1101, 1125} Oversized Injector Sleeves for Remanufactured Cylinder Heads On Medium Sized Engines{1100, 1101, 1125}
793F and 797F Off-Highway Trucks Power Train Electronic Control System Retarder Is Aggressive
2009/10/29 A New Bowl for the Fuel/Water Separator Is Used {1261, 1263}
2009/10/29 A New Bowl for the Fuel/Water Separator Is Available {1261, 1263}
C9.3 Tier 4 Final Engines Crankcase Pressure Sensor
3508C, 3512C, and 3516C Locomotive Engines Acceleration Is Poor or Throttle Response Is Poor
Improved Method for Installing the Actual Gear Position Sensor {1439, 3061} Improved Method for Installing the Actual Gear Position Sensor {1439, 3061}
797 and 797B Off-Highway Truck/Tractor Engine Air Filter Secondary Element - Replace
C9.3 Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
C9.3 Tier 4 Final Engines Water Temperature Regulator
C13 Engines for Caterpillar Built Machines Muffler - Remove and Install - Clean Emissions Module