Improved Outlet Pipe for the Turbocharger{1052, 1353}
- Engine:
- C6.6 (S/N: N6D1-1189)
Introduction
There have been a number of isolated issues with 274-1943 Pipe . The 274-1943 Pipe has been installed too close to the battery. This may melt the battery. An improved 295-0465 Pipe As has replaced 274-1943 Pipe . The improved 295-0465 Pipe As will provide sufficient clearance between the battery and the 295-0465 Pipe As . Illustration 1 shows 274-1943 Pipe in position. Illustration 2 shows 295-0465 Pipe As in position.
Show/hide table
Illustration 1 | g01906055 |
Typical example |
Show/hide table
Illustration 2 | g01906056 |
Typical example |
Removal Procedure
- Remove 274-1943 Pipe .
- Loosen band clamp (2) .
Show/hide table
Illustration 3 | g01894985 |
Typical example |
- Rotate the compressor housing (1) of the turbocharger from twenty degrees from the vertical axis to thirty degrees from the vertical axis.
- Tighten band clamp (2) finger tight.
Installation Procedure
- Install 295-0465 Pipe As to the turbocharger. Ensure that 295-0465 Pipe As is correctly aligned. If necessary, adjust the compressor housing of the turbocharger.
- Tighten band clamp (2) to a torque of 13 N·m (9.6 lb ft).
- Tighten clamps (3) to a torque of 7.5 N·m (66 lb in).
Show/hide table
Illustration 4 | g01894994 |
Typical example |
Caterpillar Information System:
C-15 Petroleum Engine Engine Speed/Timing Sensors - Check/Clean/Calibrate
C13 Engines for Caterpillar Built Machines Ignition Coil - Remove and Install - Clean Emissions Module
C-15 and C-16 Industrial Engines Engine Speed/Timing Sensors - Check/Clean/Calibrate
C9.3 Engines for Caterpillar Built Machines Injector Trim File - Install
C13 Tier 4 Final Engines General Information - C13 Engines
2009/04/27 How Is Service Information Accessed / Used {1000}
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1437 - FMI 05
C9.3 Engines for Caterpillar Built Machines ECM Software - Install
C27 and C32 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install - C32
3412C Generator Set Generator Bearing Temperature - Measure/Record
C9.3 Engines for Caterpillar Built Machines Electrical Connectors - Inspect
C11 and C13 Industrial Engines Turbocharger
793F CMD (Conversion) Off-Highway Truck Braking System MID 116 - CID 0835 - FMI 08
C15 and C18 Industrial Engines Air Inlet Elbow - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Exhaust Gas Valve (NRS) - Assemble
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1607 - FMI 03
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1607 - FMI 05
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1607 - FMI 06
C13 Tier 4 Final Engines Electronic Control System Components
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1608 - FMI 03
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1608 - FMI 05
C1.5 and C2.2 Industrial Engines Cold Weather Starting
C7.1 Industrial Engine and Generator Set CAN Data Link Circuit - Test
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 1608 - FMI 06