Belt Tensioner - Inspect
Show/hide table
| |
| Illustration 1 | g01880953 |
|
Typical example | |
Remove the belt. Refer to Disassembly and Assembly, "Alternator Belt - Remove and Install".
Ensure that the belt tensioner is securely installed. Visually inspect the belt tensioner (1) for damage. Check that the pulley on the tensioner rotates freely and that the bearing is not loose. Some engines have a idler pulley (2). Ensure that the idler pulley is securely installed. Visually inspect the idler pulley for damage. Ensure that the idler pulley can rotate freely and that the bearing is not loose. If necessary, replace damaged components.
Install the belt. Refer to Disassembly and Assembly, "Alternator Belt - Remove and Install".
Caterpillar Information System:
C7.1 Industrial Engine Engine Oil and Filter - Change
C7.1 Industrial Engine and Generator Set Engine Does Not Crank
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Electric Starting Motor
C9.3 Engines for Caterpillar Built Machines Service Information Report
2009/04/13 Do Not Adjust the Desired Speed During a Normal Stop for a Gas Engine with an ADEM 3 Control Module {1901, 1920}
C15 and C18 Industrial Engines Muffler - Remove and Install - Clean Emissions Module
C13 Engine for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Pressure Sensor - Calibrate
C15 and C18 Industrial Engines Exhaust Combustion Manifold (ARD) - Remove and Install
C13 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C9.3 Engines for Caterpillar Built Machines Engine Monitoring System
C7.1 Industrial Engine and Generator Set Engine Shutdown Occurs Intermittently
C7.1 Industrial Engine and Generator Set Oil Pressure Is Low
C7.1 Industrial Engine and Generator Set Engine Has Mechanical Noise (Knock)
C7.1 Industrial Engine and Generator Set Cylinder Is Noisy
C18 Power Module Maintenance Interval Schedule
C18 Power Module Maintenance Interval Schedule - Standby
C15 and C18 Industrial Engines Diesel Particulate Filter - Remove and Install - Clean Emissions Module
C7.1 Industrial Engine and Generator Set Valve Lash Is Excessive
C6.6 Industrial Engine Refill Capacities and Recommendations
2009/04/13 Reworked Air Compressors Now Have "R" on the Serial Number Plate {1803, 1804}
2009/04/01 Reworked Air Compressors Now Have "R" on the Serial Number Plate {1803, 1804}