Inlet Manifold Temperature Sensor - Remove and Install
Removal Procedure
- Disconnect the harness assembly and remove intake manifold temperature sensor (1) .
Show/hide table
Illustration 1 | g01880580 |
Installation Procedure
- Install intake manifold temperature sensor (1) in reverse order of removal.
- Tighten intake manifold temperature sensor (1) to a torque of 20 ± 3 N·m (177 ± 27 lb in).
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
C13 Tier 4 Final Engines Fuel System
C13 Engine for Caterpillar Built Machines Crankcase Pressure Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
C7.1 Industrial Engine and Generator Set Engine Speed Does Not Change
C13 Engine for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
C7.1 Industrial Engine and Generator Set Coolant Contains Oil
C13 Engine for Caterpillar Built Machines Camshaft Position Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Bearing Clearance - Check
C15 and C18 Industrial Engines Exhaust Combustion Manifold (ARD) - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Pressure Sensor - Calibrate
C13 Engine for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Muffler - Remove and Install - Clean Emissions Module
2009/04/13 Do Not Adjust the Desired Speed During a Normal Stop for a Gas Engine with an ADEM 3 Control Module {1901, 1920}
C9.3 Engines for Caterpillar Built Machines Service Information Report
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Electric Starting Motor
C7.1 Industrial Engine and Generator Set Engine Does Not Crank
C7.1 Industrial Engine Engine Oil and Filter - Change
C7.1 Industrial Engine Belt Tensioner - Inspect
C9.3 Engines for Caterpillar Built Machines Engine Monitoring System
C7.1 Industrial Engine and Generator Set Engine Shutdown Occurs Intermittently