Crankcase Pressure Sensor - Remove and Install
Start By:
- Remove the accessory drive.
- Disconnect harness assembly (1) and position harness assembly (1) out of the way.
Show/hide table
Illustration 2 g02176429 - Remove four bolts (2) and bracket (3).
- Remove crankcase pressure sensor (4).
Show/hide table
Illustration 1 | g01880500 |
- Install crankcase pressure sensor (1) in reverse order of removal.
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
C7.1 Industrial Engine and Generator Set Engine Speed Does Not Change
C13 Engine for Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
C7.1 Industrial Engine and Generator Set Coolant Contains Oil
C13 Engine for Caterpillar Built Machines Camshaft Position Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Bearing Clearance - Check
C13 Engines for Caterpillar Built Machines Crankshaft - Remove
C13 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
C13 Engines for Caterpillar Built Machines Crankshaft - Install
C13 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
C4.4 Industrial Engine Engine Electronics
C13 Tier 4 Final Engines Fuel System
C13 Engine for Caterpillar Built Machines Fuel Pressure Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install
C13 Engine for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
C13 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor - Remove and Install
C15 and C18 Industrial Engines Exhaust Combustion Manifold (ARD) - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Pressure Sensor - Calibrate
C13 Engine for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Muffler - Remove and Install - Clean Emissions Module
2009/04/13 Do Not Adjust the Desired Speed During a Normal Stop for a Gas Engine with an ADEM 3 Control Module {1901, 1920}
C9.3 Engines for Caterpillar Built Machines Service Information Report
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Electric Starting Motor