- Marine Engine:
- C15 MARINE (S/N: RLA1-909)
- C18 MARINE (S/N: CKH1-3070; C1J1-1087)
- C32 MARINE (S/N: RNC1-3072)
- C18 MARINE (S/N: CKH1-3070; C1J1-1087)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
The 197-8832 Service Meter Gp runs constantly when power is applied to the ECM.
Solution
The 300-5538 Wire that contains a 1 kOhm, 2 Watt resistor can be installed in the Start/Stop control group if the engine is equipped with a 203-4624 Auto Start/Stop Control . The 300-5538 Wire and the connections for the Start/Stop control harness need to be sealed with heat shrink tubing. The 114-2505 Film can be applied to the service meter in order to provide the correction factor for the correct number of engine hours.
Illustration 1 | g01405231 |
Wiring schematic |
Illustration 2 | g01391062 |
Wiring schematic (1) Apply heat shrink tubing to the connections of the Start/Stop control harness. |