Water Pump - Remove
Start By:
- Remove the fan and the fan pulley. Refer to Disassembly and Assembly, "Fan - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
- Loosen the hose clamps and remove the hose from the water pump inlet.
Show/hide table
Illustration 1 g01263054 Typical example - Remove bolts (4). The bolts are different lengths. Note the positions of the different bolts.
Note: Do not remove bolts (7) at this time.
- Remove water pump (3) from front cover (1).
Note: If necessary, tap the water pump with a soft hammer in order to loosen the water pump.
- Remove joint (2).
- If necessary, remove cover (6) from the water pump. Follow Steps 6.a through 6.c in order to remove the cover.
- Remove bolts (7).
- Remove cover (6).
- Remove joint (5).
Caterpillar Information System:
C3.3 Industrial Engine Engine Oil Pump - Remove and Install
C3.3 Industrial Engine Engine Oil Relief Valve - Remove and Install
C3.3 Industrial Engine Engine Oil Cooler - Install
C3.3 Industrial Engine Engine Oil Cooler - Remove
C3.3 Industrial Engine Engine Oil Filter Base - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valve Guides - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
C3.3 Industrial Engine Exhaust Elbow - Remove and Install
C3.3 Industrial Engine Exhaust Manifold - Remove and Install
C3.3 Industrial Engine Turbocharger - Install
C3.3 Industrial Engine Fuel Injector Cover - Remove and Install
C3.3 Industrial Engine Water Pump - Install
C3.3 Industrial Engine Water Temperature Regulator - Remove and Install
C3.3 Industrial Engine Flywheel - Remove
C3.3 Industrial Engine Flywheel - Install
C3.3 Industrial Engine Crankshaft Rear Seal - Remove
C3.3 Industrial Engine Crankshaft Rear Seal - Install
C3.3 Industrial Engine Flywheel Housing - Remove and Install
C3.3 Industrial Engine Crankshaft Pulley - Remove and Install
C3.3 Industrial Engine Crankshaft Wear Sleeve (Front) - Remove and Install
C3.3 Industrial Engine Crankshaft Front Seal - Remove and Install
C3.3 Industrial Engine Housing (Front) - Remove
C3.3 Industrial Engine Gear Group (Front) - Remove and Install