Flywheel - Remove
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | - | Guide Bolt 1/2 inch - UNF by 4 inch |
2 |
Start By:
- Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove two bolts from Positions (X) on flywheel (1).
- Install Tooling (A) to Positions (X) on flywheel (1).
- Attach a suitable lifting device to flywheel (1). Support the weight of flywheel (1). The weight of flywheel (1) is approximately
71 kg (155 lb) . - Remove remaining bolts (2).
- Use the lifting device in order to remove the flywheel from the engine.
Show/hide table
Illustration 2 g01245152 Typical example - Inspect flywheel (1) and ring gear (3) for wear or damage. Replace any components that are worn or damaged.
- To remove the flywheel ring gear, follow Steps 7.a and 7.b.
- Place the flywheel assembly on a suitable support.
Note: Identify the orientation of the teeth on the flywheel ring gear.
- Use a hammer and a punch in order to remove ring gear (3) from flywheel (1).
- Place the flywheel assembly on a suitable support.
Show/hide table
Illustration 1 | g01401982 |
Typical example |
Caterpillar Information System:
C3.3 Industrial Engine Water Temperature Regulator - Remove and Install
C3.3 Industrial Engine Water Pump - Install
C3.3 Industrial Engine Water Pump - Remove
C3.3 Industrial Engine Engine Oil Pump - Remove and Install
C3.3 Industrial Engine Engine Oil Relief Valve - Remove and Install
C3.3 Industrial Engine Engine Oil Cooler - Install
C3.3 Industrial Engine Engine Oil Cooler - Remove
C3.3 Industrial Engine Engine Oil Filter Base - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valve Guides - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
C3.3 Industrial Engine Exhaust Elbow - Remove and Install
C3.3 Industrial Engine Flywheel - Install
C3.3 Industrial Engine Crankshaft Rear Seal - Remove
C3.3 Industrial Engine Crankshaft Rear Seal - Install
C3.3 Industrial Engine Flywheel Housing - Remove and Install
C3.3 Industrial Engine Crankshaft Pulley - Remove and Install
C3.3 Industrial Engine Crankshaft Wear Sleeve (Front) - Remove and Install
C3.3 Industrial Engine Crankshaft Front Seal - Remove and Install
C3.3 Industrial Engine Housing (Front) - Remove
C3.3 Industrial Engine Gear Group (Front) - Remove and Install
C3.3 Industrial Engine Idler Gear - Remove
C3.3 Industrial Engine Idler Gear - Install
C3.3 Industrial Engine Housing (Front) - Install