Fuel Injector - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Ensure that the seat for the fuel injectors in the cylinder head is clean and free from damage. Position a new washer (7) on the seat for the fuel injector in the cylinder head.
- Install a new O-ring seal (6) on fuel injectors (1).
- Position clamp (4) onto fuel injectors (1). Install fuel injectors into the cylinder head.
Note: Alignment Pins (5) must be located opposite clamps (4).
- Install bolts (3). Tighten the bolts to a torque of
35 N·m (26 lb ft) . - Install fuel return lines (2) to fuel injectors (1).
Show/hide table
Illustration 1 | g01439728 |
Typical example |
End By:
- Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Install".
Caterpillar Information System:
C3.3 Industrial Engine Fuel Injector - Remove
C3.3 Industrial Engine Fuel Injection Pump Gear - Install
C3.3 Industrial Engine Fuel Injection Pump Gear - Remove
C3.3 Industrial Engine Fuel Injection Pump - Install
C3.3 Industrial Engine Fuel Injection Pump - Remove
C3.3 Industrial Engine Front Cover - Remove and Install
C3.3 Industrial Engine Fuel Injection Lines - Remove and Install
C3.3 Industrial Engine Fuel Priming Pump and Fuel Filter Base - Remove and Install
C18 Marine Engines Engine Crankcase Breather - Clean
Instructions for Determining The Secondary Voltage of the Transformer{1555, 7620} Instructions for Determining The Secondary Voltage of the Transformer{1555, 7620}
C15 On-Highway Engine Cylinder Head - Remove
3408C and 3412C Marine Engines Flywheel Housing
C3.3 Industrial Engine Turbocharger - Remove
C3.3 Industrial Engine Fuel Injector Cover - Remove and Install
C3.3 Industrial Engine Turbocharger - Install
C3.3 Industrial Engine Exhaust Manifold - Remove and Install
C3.3 Industrial Engine Exhaust Elbow - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C3.3 Industrial Engine Inlet and Exhaust Valve Guides - Remove and Install
C3.3 Industrial Engine Engine Oil Filter Base - Remove and Install
C3.3 Industrial Engine Engine Oil Cooler - Remove
C3.3 Industrial Engine Engine Oil Cooler - Install
C3.3 Industrial Engine Engine Oil Relief Valve - Remove and Install