Fuel Control Manifold (ARD) - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Inspect the O-ring seals. Replace the O-ring seals that are worn or damaged.
- Install O-ring seals (10) onto valve (8) .
Show/hide table
Illustration 1 | g03757576 |
- Repeat Step 1 for valve (9) .
- Install valves (9) and (8) . Tighten valves (9) and (8) to a torque of 50 ± 5 N·m (37 ± 4 lb ft).
Show/hide table
Illustration 2 | g03757517 |
- Install coil assemblies (7) and (6) .
Show/hide table
Illustration 3 | g03757398 |
- Install nuts (4) and (5) . Tighten nuts (5) and (4) to a torque of 20 ± 3 N·m (177 ± 27 lb in).
- Install O-ring seal (3) onto pressure sensor (1) .
Show/hide table
Illustration 4 | g03757371 |
- Repeat Step 6 for pressure sensor (2) .
- Install pressure sensors (2) and (1) . Tighten pressure sensors (2) and (1) to a torque of 20 ± 3 N·m (177 ± 27 lb in).
Show/hide table
Illustration 5 | g03757356 |
End By: Install the fuel control manifold. Refer to Disassembly and Assembly, "Fuel Control Manifold (ARD) - Install".
Caterpillar Information System:
Installation of the 129-2288 Shaft {1205, 1353, 1356, 1359} Installation of the 129-2288 Shaft {1205, 1353, 1356, 1359}
G3520B Industrial Engines Crankshaft
G3520B Industrial Engines Air/Fuel Ratio Control - NO<SUB>X</SUB> Feedback
C15 On-Highway Engine Fuel Control Manifold (ARD) - Disassemble
G3520B Industrial Engines Ignition System
G3520B Industrial Engines Engine Sensors
C7 On-highway Engine Air Inlet Elbow
325D and 329D Excavators and 325D Material Handler Machine System Specifications Control Manifold (Pilot Oil)
2008/03/17 New Product Link Hardware Is Now Available {7606}
G3520B Industrial Engines Electronic Control System Parameters
G3520B Industrial Engines Integrated Temperature Sensing Module
G3520B Industrial Engines Engine Governing
C15 On-Highway Engine Fuel Control Manifold (ARD) - Install
C3.4 Engines for Caterpillar Built Machines Balancer - Disassemble
C3.4 Engines for Caterpillar Built Machines Balancer - Assemble
C7 Marine Engine Piston and Rings
C15 On-Highway Engine Solenoid Valve (ARD) - Remove and Install
G3520B Industrial Engines System Overview
2007/07/30 An Update to the Maintenance Interval Schedule for Some Caterpillar Marine Engines {1063}
G3520B Industrial Engines Component Location
C15 On-Highway Engine Combustion Body Group (ARD) - Remove
G3520B Industrial Engines Configuration Parameters
Cat Commercial Diesel Engine Fluids Recommendations Characteristics of Diesel Fuel
Cat Commercial Diesel Engine Fluids Recommendations Fuel Recommendations