Fuel Injection Control Linkage - Remove
Removal Procedure
Start By:
- Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
- Remove the camshaft drive gears. Refer to Disassembly and Assembly, "Camshaft Drive Gear - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the camshaft inspection covers from each side of the engine.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
- Remove bolt (1) and cap (2). Move lever (3) away from the control shaft.
Show/hide table
Illustration 1 | g00629802 |
Show/hide table
Illustration 2 | g01208606 |
- Remove bolt (4) .
- Remove rod assembly (5) and lever (3) as a unit.
- Remove lever (3) from rod assembly (5) .
- Remove the bolts and plate assembly (7) from rocker arm support (6) .
Show/hide table
Illustration 3 | g01208609 |
- Remove lever (8) from plate assembly (7) .
- Remove rod assembly (9) from the fuel control shaft.
Show/hide table
Illustration 4 | g01307150 |
- Remove flange (14) from the rear of the cylinder block.
Show/hide table
Illustration 5 | g01307157 |
- Remove the nut, the washers, and bolts (11) that connect shaft assemblies (12) and (13) together.
- Move shaft assembly (12) away from bracket (10) .
- Remove shaft assembly (12) through the opening in the rear of the engine.
- Remove the bolts and bracket (10) .
- Remove shaft assembly (13) through the opening in the rear of the engine.
Caterpillar Information System:
C15 and C18 Petrolem Generator Set Engines Exhaust Has Excessive White Smoke
C15 and C18 Petrolem Generator Set Engines Exhaust Has Excessive Black Smoke
C15 and C18 Petrolem Generator Set Engines Engine Vibration Is Excessive
TH48-E70 Petroleum Transmission and TH48-E70-C27I, TH48-E70-C32I and TH48-E70-C32P Petroleum Power Train Packages Torque Converter
C11 and C13 Engines and 14M and 16M Motor Graders Engine Top Speed Is Not Obtained
C15 On-Highway Engine Diesel Particulate Filter Temperature and Pressure Sensor
3500C Marine Auxiliary Engines Engine Stalls at Low RPM
C15 and C18 Petrolem Generator Set Engines Engine Shutdown Occurs Intermittently
C11 and C13 Engines and 14M and 16M Motor Graders Engine Overspeeds
C11 and C13 Engines and 14M and 16M Motor Graders Engine Misfires, Runs Rough or Is Unstable
Electrical Application and Installation Guide for the CX28, CX31, and CX35 On-Highway Transmissions {1408, 3030, 3168} Electrical Application and Installation Guide for the CX28, CX31, and CX35 On-Highway Transmissions {1408, 3030, 3168}
CX31 On-Highway Transmission Warranty Information
C15 and C18 Petrolem Generator Set Engines Exhaust Temperature Is High
C15 and C18 Petrolem Generator Set Engines Fuel Consumption Is Excessive
C15 On-Highway Engine Diesel Particulate Filter
C11 and C13 Engines and 14M and 16M Motor Graders Fuel Pressure Is High
C11 and C13 Engines and 14M and 16M Motor Graders Fuel Temperature Is High
C13 On-highway Engine Diesel Particulate Filter
2006/09/25 Correct Installation Procedure for the 235-1448 Tube As {1306}
C11 and C13 Engines and 14M and 16M Motor Graders Idle Speed Is High
Exhaust Temperature Module System Description
C11 and C13 Engines and 14M and 16M Motor Graders Inlet Air Is Restricted
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel System Primary Filter/Water Separator - Drain
C11 and C13 Engines and 14M and 16M Motor Graders Intake Manifold Air Temperature Is High