Rocker Arm - Assemble
组装步骤
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 用清洁的发动机机油润滑所有摇臂轴零部件。
- 将弹簧 (3) 、支架 (4) 、进气摇臂 (5) 、排气摇臂 (6) 和端架 (7) 安装到摇臂轴 (1) 上。
Show/hide table
 | |
| 图 1 | g01259141 |
Show/hide table
 |
弹簧压缩零件如果安装不当，会伤害人体。 为避免伤害，遵照出版的装配程序，并穿上保护装备。 |
- 将定位销 (2) 安装到摇臂轴 (1) 上。
End By: 安装摇臂和摇臂轴。 请参阅 拆解和组装, "摇臂和轴 - 安装"。
Caterpillar Information System:
C7 PETROLEUM Petroleum Engine Rocker Arm and Shaft - Install
C7 On-Highway Engine Fan Drive Mounting Group - Remove and Install
3456 Generator Sets Maintenance Interval Schedule - Standby Generator Sets
3456 Generator Sets Maintenance Interval Schedule - Prime Power Generator Sets
C7 PETROLEUM Petroleum Engine Rocker Arm - Disassemble
3500B and 3500C Locomotive Engines Prelubrication System
C7 On-Highway Engine Fuel Manifold (Rail) - Remove and Install
C7 PETROLEUM Petroleum Engine Rocker Arm and Shaft - Remove
3500B and 3500C Locomotive Engines Override Switch
2006/04/01 Improved Software is Now Used {7620}
C15 Industrial Engine Injector Solenoid Circuit - Test
3500B and 3500C Locomotive Engines Fuel Position Multiplier
C4.4 Industrial Engine Introduction
3500B and 3500C Locomotive Engines Pulse Width Modulated Sensor
3500B and 3500C Locomotive Engines Sensor Supply
Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073} Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073}
Update of the Initial Flash Procedure for the Primary ECM{0785, 7620} Update of the Initial Flash Procedure for the Primary ECM{0785, 7620}
C4.4 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace
C7 PETROLEUM Petroleum Engine Cylinder Head - Remove
3500B and 3500C Locomotive Engines Starting Motor System
C15 and C18 Petroleum Generator Sets Generator Lead - Check
C7 On-Highway Engine Clean Gas Induction Valve - Install
C4.4 Industrial Engine Fuel System Secondary Filter - Replace
C7 On-Highway Engine Combustion Head - Remove and Install