Rocker Arm and Shaft - Install
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | 8T-2998     | 润滑剂     | 1     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 在推杆两端涂抹工具 (A) 。
- 用清洁的发动机机油润滑推杆。 安装推杆和气门桥。
- 在缸盖上定位摇臂轴 (4) 。 安装螺栓 (1) 并按照数字顺序上紧螺栓。
Show/hide table
图 1 | g01259077 |
Show/hide table
图 2 | g01518624 |
- 在各个摇臂底面上涂抹工具 (A) 。
- 定位摇臂调整螺钉 (2) 并拧紧螺母 (3) 。 调整摇臂的气门间隙。 请参阅测试与调整, "发动机气门间隙 - 检查 / 调整"。
End By: 安装气门机构盖。 请参阅 拆解和组装, "气门机构盖 - 拆卸和安装"。
Caterpillar Information System:
C7 On-Highway Engine Fan Drive Mounting Group - Remove and Install
3456 Generator Sets Maintenance Interval Schedule - Standby Generator Sets
3456 Generator Sets Maintenance Interval Schedule - Prime Power Generator Sets
C7 PETROLEUM Petroleum Engine Rocker Arm - Disassemble
3500B and 3500C Locomotive Engines Prelubrication System
C7 On-Highway Engine Fuel Manifold (Rail) - Remove and Install
C7 PETROLEUM Petroleum Engine Rocker Arm and Shaft - Remove
3500B and 3500C Locomotive Engines Override Switch
2006/04/01 Improved Software is Now Used {7620}
C15 Industrial Engine Injector Solenoid Circuit - Test
3500B and 3500C Locomotive Engines Fuel Position Multiplier
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Startup (SMS) - Single Module System
C7 PETROLEUM Petroleum Engine Rocker Arm - Assemble
C4.4 Industrial Engine Introduction
3500B and 3500C Locomotive Engines Pulse Width Modulated Sensor
3500B and 3500C Locomotive Engines Sensor Supply
Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073} Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073}
Update of the Initial Flash Procedure for the Primary ECM{0785, 7620} Update of the Initial Flash Procedure for the Primary ECM{0785, 7620}
C4.4 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace
C7 PETROLEUM Petroleum Engine Cylinder Head - Remove
3500B and 3500C Locomotive Engines Starting Motor System
C15 and C18 Petroleum Generator Sets Generator Lead - Check
C7 On-Highway Engine Clean Gas Induction Valve - Install
C4.4 Industrial Engine Fuel System Secondary Filter - Replace