Fan Drive Mounting Group - Remove and Install
Start By:
- Remove the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
- Remove bolts (2), bolts (3), and bolts (4). Remove support assembly (5). Remove screws (1).
Show/hide table
Illustration 2 g01259310 - Remove bolts (6). Remove fan pulley (7).
Show/hide table
Illustration 3 g01259312 - Remove bolts (9). Remove fan drive mounting group (10). Lifting bracket (8) will be removed when you remove fan drive mounting group (10).
Show/hide table
| |
| Illustration 1 | g01259309 |
- Position lifting bracket (8). Install fan drive mounting group (10). Install bolts (9).
Show/hide table
Illustration 5 g01259310 - Install fan pulley (7). Install bolts (6).
Show/hide table
Illustration 6 g01259309 - Install screws (1). Install support assembly (5). Install bolts (2), bolts (3), and bolts (4).
Show/hide table
| |
| Illustration 4 | g01259312 |
End By:
- Install the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Caterpillar Information System:
3456 Generator Sets Maintenance Interval Schedule - Standby Generator Sets
3456 Generator Sets Maintenance Interval Schedule - Prime Power Generator Sets
C7 PETROLEUM Petroleum Engine Rocker Arm - Disassemble
3500B and 3500C Locomotive Engines Prelubrication System
C7 On-Highway Engine Fuel Manifold (Rail) - Remove and Install
C7 PETROLEUM Petroleum Engine Rocker Arm and Shaft - Remove
3500B and 3500C Locomotive Engines Override Switch
2006/04/01 Improved Software is Now Used {7620}
C15 Industrial Engine Injector Solenoid Circuit - Test
3500B and 3500C Locomotive Engines Fuel Position Multiplier
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Startup (SMS) - Single Module System
3500B and 3500C Locomotive Engines Ether Injection System
C7 PETROLEUM Petroleum Engine Rocker Arm and Shaft - Install
C7 PETROLEUM Petroleum Engine Rocker Arm - Assemble
C4.4 Industrial Engine Introduction
3500B and 3500C Locomotive Engines Pulse Width Modulated Sensor
3500B and 3500C Locomotive Engines Sensor Supply
Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073} Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073}
Update of the Initial Flash Procedure for the Primary ECM{0785, 7620} Update of the Initial Flash Procedure for the Primary ECM{0785, 7620}
C4.4 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace
C7 PETROLEUM Petroleum Engine Cylinder Head - Remove
3500B and 3500C Locomotive Engines Starting Motor System
C15 and C18 Petroleum Generator Sets Generator Lead - Check
C7 On-Highway Engine Clean Gas Induction Valve - Install