Reduced Rimpull Setting (Operator Monitor) - Adjust
The impeller clutch must be calibrated if any of the following conditions have occurred:
- The solenoid has been replaced.
- The Power Train ECM has been replaced.
- The calibration has been required by a service code.
- Engage the parking brake.
- Disengage the transmission lock lever.
- Shift the transmission direction switch to the NEUTRAL position.
- Make sure that the machine ground speed is zero.
- Set the engine speed to high idle.
- Press the "OK" button on the keypad repeatedly. The hour meter will appear on the diagnostic message screen.
- Enter SERV (7378) by using the keypad. Press the "OK" button.
- Press the ">" button until the diagnostic message screen displays "SELECT CALIBRATION REDUCED RIMPULL - SET".
- Press the "OK" button. The screen will display "REDUCED RIMPULL - SET PRESS [OK] TO START".
- Follow the instructions on the diagnostic message screen in order to complete the procedure.
Caterpillar Information System:
Replacement of the Electrohydraulic Control Group on the 834G Wheel Dozer{5702, 5705} Replacement of the Electrohydraulic Control Group on the 834G Wheel Dozer{5702, 5705}
C27 and C32 Engines for Caterpillar Built Machines Compression Brake Solenoid Circuit - Test
C4.4 Industrial Engine Accessory Drive - Install
C4.4 Industrial Engine Accessory Drive - Assemble
C4.4 Industrial Engine Accessory Drive - Disassemble
C4.4 Industrial Engine Accessory Drive - Remove
993K Wheel Loader VIMS Loader Payload System Glossary of Terms
993K Wheel Loader VIMS Loader Payload System VIMSpc Payload Reports
993K Wheel Loader VIMS Loader Payload System VIMSpc Onboard Configuration
993K Wheel Loader VIMS Loader Payload System VIMSpc Software
993K Wheel Loader VIMS Loader Payload System Service Tool Software
993K Wheel Loader VIMS Loader Payload System Calibration
993K Wheel Loader Power Train Reduced Rimpull Setting (Electronic Technician) - Adjust
993K Wheel Loader Power Train Electronic Control Module (ECM) - Replace
993K Wheel Loader Power Train Electronic Control Module (ECM) - Configure
C27 and C32 Engines for Caterpillar Built Machines Switch Circuits - Test
854K Wheel Dozer and 992K Wheel Loader Power Train Electronic Control Module (ECM) - Flash Program
973D Track-Type Loader Engine Supplement Engine Oil Filter, Oil Filter Base and Oil Cooler - Remove and Install
2008/02/04 Correction to Special Instruction, REHS0248, "Field Assembly of 854G Wheel Dozer" {7000, 7960}
Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091} Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091}
973D Track-Type Loader Engine Supplement Engine - Remove
973D Track-Type Loader Engine Supplement Engine - Install
C11 and C13 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
992K Wheel Loader and 854K Wheel Dozer Power Train Duo-Cone Conventional Seals - Install