- COM adapter II
- Service tool cables
- Caterpillar Electronic Technician software
- VIMS-PC software
- 6V-7070 Digital Multimeter, 9U-7330 Digital Multimeter or an equivalent
- 8T-3224 Needle Tip Group
- 7X-1710 Probe Cable Group
- 8T-8726 Adapter Cable
- 6V-3000 Sure-Seal Repair Kit
- 4C-3406 Deutsch Connector Repair Kit
- 9U-6665 Switch Box
Note: For more information about Caterpillar Electronic Technician software and about VIMSpc software, Refer To Troubleshooting, "Using Caterpillar Electronic Technician to Determine Diagnostic Codes" and Troubleshooting, "Using the Operator Monitor to Determine Diagnostic Codes".
Use the digital multimeter for making continuity checks or for measuring voltage. For instructions about the use of the 6V-7070 Digital Multimeter, see Special Instruction, SEHS7734. The 7X-1710 Probe Cable Group is used for measuring voltage at the connectors without needing to disconnect the connectors. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a 3 pin breakout. The adapter cable is used for measurements in the sensor circuits.
Note: Except for harness tests, using continuity testers such as the 8T-0500 Continuity Tester or voltage testers such as the 5P-7277 Voltage Tester is not recommended for today's Caterpillar electrical circuits.