Fuel Tank - Remove and Install
开始:
- 拆卸发动机。 请参考拆解和组装, "发动机 - 拆卸"。
- 拆下注油泵。 请参阅拆解和装配, "燃油加注泵和粗滤器(油水分离器)- 拆卸和安装"。
注: 在所有软管、所有软管组件、所有导线及所有管组件上作出识别标记,以便安装。 插接好所有软管组件和所有管组件。 这将有助于防止液体渗漏,并有助于防止污染物进入系统。
注: 清洁度是一项重要的因素。 拆卸步骤开始之前,应彻底清洁部件外部。 这有助于防止尘土进入内部结构。
Show/hide table
注意 |
---|
在进行检验、保养、测试、调整及维修产品期间,必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前,要准备好合适的容器收集液体。 有关收集和盛接 Cat 产品上油液的适用工具和用品,请参阅专门出版物, NENG2500, "代理商维修工具目录"。 按照当地法规和要求处置所有液体。 |
- 排空油箱 请参阅操作和保养手册, "燃油箱水和沉积物 - 排放"了解正确的步骤。
Show/hide table
图 1 g01342129 - 拆下支架 (1)。 拆下卡箍 (2) 和 (3)。
Show/hide table
图 2 g01342132 - 拆下卡箍 (4)。 断开线束组件 (6)、软管 (7) 和管组件 (5)。 将管组件 (5) 放到一旁。
Show/hide table
图 3 g01342159 - 拆下护罩组件 (10)。 拆下支架 (8)。
- 拆下燃油箱 (9)。
注: 清洁度是一项重要的因素。 组装之前,应使用清洗剂彻底清洁所有零件。 让零件风干。 请勿使用抹布擦干零件。 棉绒可能会留在零件上,从而引发故障。 检查所有零件。 如果任何零件磨损或损坏,则应使用新零件进行更换。 尘土及其他污染物可能会损坏精密部件。 组装步骤应在清洁的工作面上进行。 务必盖上部件并采取适当保护措施。
注: 检查 O 形密封圈、垫片和密封件有无磨损或损坏。 如有必要,请更换部件。
Show/hide table
注意 |
---|
在进行检验、保养、测试、调整及维修产品期间,必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前,要准备好合适的容器收集液体。 有关收集和盛接 Cat 产品上油液的适用工具和用品,请参阅专门出版物, NENG2500, "代理商维修工具目录"。 按照当地法规和要求处置所有液体。 |
- 安装燃油箱 (9)。
- 安装支架 (8)。 安装防护罩组件 (10)。
Show/hide table
图 5 g01342132 - 连接管组件 (5)、软管 (7) 和线束组件 (6)。 安装卡箍 (4)。
Show/hide table
图 6 g01342129 - 安装卡箍 (2) 和 (3)。 安装支架 (1)。
- 加注燃油箱。
Show/hide table
图 4 | g01342159 |
结束:
- 安装注油泵。 请参阅拆解和装配, "燃油加注泵和粗滤器(油水分离器)- 拆卸和安装"。
- 安装发动机。 请参考拆解和组装, "发动机 - 安装"。
Caterpillar Information System:
3524B Engines for 797 and 797B Off-Highway Trucks Checking Engine Cylinders
2007/01/29 Improvements to the Mounting Plates of the Tilt Cylinders {5104}
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Throttle Lock - Test
C15 and C18 Petrolem Generator Set Engines Engine Stalls at Low RPM
Installation Instructions for the 2Q-8720 Machine Performance Gp (Fuel Management System) (Kit) for the 988H{1052, 3101} Installation Instructions for the 2Q-8720 Machine Performance Gp (Fuel Management System) (Kit) for the 988H{1052, 3101}
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Engine Misfires, Runs Rough or Is Unstable
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Engine Overspeeds
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Acceleration Is Poor or Throttle Response Is Poor
Increase the Service Life of the Elevator Chain Idler on Certain Wheel Tractor-Scrapers{6241} Increase the Service Life of the Elevator Chain Idler on Certain Wheel Tractor-Scrapers{6241}
IT38H Integrated Toolcarrier and 938H Wheel Loader Engine Supplement Gear Motor (Hydraulic Fan) - Assemble
816F Series 2 Landfill Compactor, 815F Series 2 Soil Compactor and 814F Series 2 Wheel Dozer MID 081 - CID 1406 - FMI 13
816F Series 2 Landfill Compactor, 815F Series 2 Soil Compactor and 814F Series 2 Wheel Dozer MID 081 - CID 1405 - FMI 13
2008/08/11 Improved Oil Pressure Senders Are Now Available {1924}
IT38H Integrated Toolcarrier and 938H Wheel Loader Machine Systems Pilot Oil Accumulator (Dead Engine, Lift Arm Lower) - Remove and Install
613G Wheel Tractor-Scraper Safety Messages
PL1000E Communication ECM Data Link Address of Caterpillar Electronic Control
PL1000E Communication ECM Hexadecimal Conversion
Installation Of CD700 Display On A D6R Or D7R Machine That Is Configured For A CD550 Display{7490} Installation Of CD700 Display On A D6R Or D7R Machine That Is Configured For A CD550 Display{7490}
IT38H Integrated Toolcarrier and 938H Wheel Loader Machine Systems Brake Accumulator - Remove and Install
C4.2 and C6.4 Engines for Caterpillar Built Machines Welding Precaution
Product Link PL121SR{7606} Product Link PL121SR{7606}
14L Motor Grader All Wheel Drive Electronic Control System Wiring Harness (Open Circuit) - Test
14L Motor Grader All Wheel Drive Electronic Control System Wiring Harness (Short Circuit) - Test
2009/05/04 Wear Plates for the Dump Body now Available {6820, 7258}