Flywheel
Show/hide table
 | |
| Illustration 1 | g01231100 |
Typical example | |
Note: Refer to Systems Operation/Testing and Adjusting for the correct method of inspecting the flywheel.
(1) Bolt
- Tighten bolts (1) that hold the flywheel to the crankshaft to the following torque. ... 120 ± 20 N·m (90 ± 15 lb ft)
(2) Ring gear
Caterpillar Information System:
Installation of the 422-9537 Repair Kit {1233} Installation of the 422-9537 Repair Kit {1233}
C9 Generator Set Engine Aftercooler - Install
CX31 On-Highway Transmission Power Train Control Manifold - Disassemble
CX31 On-Highway Transmission Power Train Control Manifold - Install
C6.6 Generator Set Engine Temperature Sensor Open or Short Circuit - Test
C9 Generator Set Engine Aftercooler - Remove
2006/01/02 Improved Starter Relay Available {1426, 4493}
SR5 Electric Power Generation Exciter Field - Flash
325D and 329D Excavators Hydraulic System Pilot Valve (Swing Parking Brake)
C6.6 Engines for Caterpillar Built Machines Exhaust Manifold
C9 Generator Set Engine Engine - Install
SR5 Electric Power Generation Leads - Connect
CX31 On-Highway Transmission Power Train Control Manifold - Assemble
2006/10/09 Replacement Idler Gear Assembly {1206, 1207}
C6.6 Generator Set CID 0041 FMI 03
C6.6 Generator Set E360 Low Engine Oil Pressure
C6.6 Generator Set CID 0041 FMI 04
3126B and 3126E Truck Engines Flywheel
Service Replacement Relays Available{4493} Service Replacement Relays Available{4493}
345B Excavator and 345B Material Handler Machine System Specifications Bucket Adjuster
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Declaration of Conformity
3406E and C15 Marine Engines Declaration of Conformity
C18 Marine Auxiliary Engine Declaration of Conformity
C32 Auxiliary Engine Declaration of Conformity