E360 Low Engine Oil Pressure
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects a fault with the engine's oil pressure. The ECM detects the following faults:
- The engine has been running for more than ten seconds.
- The oil pressure is below the trip point for the event code. Refer to Table 1 for a list of trip points for low oil pressure.
- Diagnostic code 100-3 Engine Oil Pressure open/short to +batt is not active.
- Diagnostic code 100-4 Engine Oil Pressure short to ground is not active.
Note: This event code represents an event. This does not represent an electronic system fault.
Show/hide table
Trip Points for Low Oil Pressure     | ||||
    | E360-1     | E360-3     | ||
    | RPM     | kPa Gauge     | RPM     | kPa Gauge     |
Trip level     | 0     | 0     | 0     | 0     |
1500 | 250 kPa (36 psi)     |
1500     | 100 kPa (14 psi)     |
|
1800 | 250 kPa (36 psi)     |
1800     | 100 kPa (14 psi)     |
|
Delay to activation     | 8 seconds     | 4 seconds     |
System Response:
The event code will be logged.
The warning lamp will be illuminated and the diagnostic lamp will flash the event code.
E360-1
None
E360-3
The derate lamp will be illuminated. The ECM will derate the power at 17 percent per second for two seconds.
The shutdown lamp will be illuminated. If the "Enable Shutdown" parameter is enabled, the engine will shut down.
Test Step 1.
Refer to Troubleshooting, "Low Engine Oil Pressure".
Results:
- OK - STOP
Caterpillar Information System:
C6.6 Generator Set CID 0041 FMI 03
2006/10/09 Replacement Idler Gear Assembly {1206, 1207}
CX31 On-Highway Transmission Power Train Control Manifold - Assemble
3126B and 3126E Truck Engines Flywheel
Installation of the 422-9537 Repair Kit {1233} Installation of the 422-9537 Repair Kit {1233}
C9 Generator Set Engine Aftercooler - Install
CX31 On-Highway Transmission Power Train Control Manifold - Disassemble
CX31 On-Highway Transmission Power Train Control Manifold - Install
C6.6 Generator Set Engine Temperature Sensor Open or Short Circuit - Test
C9 Generator Set Engine Aftercooler - Remove
2006/01/02 Improved Starter Relay Available {1426, 4493}
SR5 Electric Power Generation Exciter Field - Flash
C6.6 Generator Set CID 0041 FMI 04
3126B and 3126E Truck Engines Flywheel
Service Replacement Relays Available{4493} Service Replacement Relays Available{4493}
345B Excavator and 345B Material Handler Machine System Specifications Bucket Adjuster
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Declaration of Conformity
3406E and C15 Marine Engines Declaration of Conformity
C18 Marine Auxiliary Engine Declaration of Conformity
C32 Auxiliary Engine Declaration of Conformity
3412E and C30 Marine Engines Declaration of Conformity
C6.6 Engines for Caterpillar Built Machines Camshaft
349F and 352F Excavators Machine System Specifications Bucket Linkage
3412E and C30 Marine Engines Safety Messages