Rocker Shaft and Pushrod - Remove
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 6K-0806 | Cable Strap | 3 |
Start By:
- Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- If the rocker shaft will not be disassembled, install the cable straps (5) around the rocker arms (1) in order to slightly compress the springs. The rocker arms must be held away from the machined faces of the cylinder head (4) during installation.
- Remove the Torx screws (6) from the rocker shaft (2).
- Remove the rocker shaft assembly from the cylinder head.
- Remove the pushrods (3) from the cylinder head. Place an identification mark on each of the pushrods. Ensure that the pushrods are installed in the correct order when the rocker shaft is replaced.
Show/hide table
| |
| Illustration 1 | g01233272 |
Show/hide table
| |
| Illustration 2 | g01233113 |
Show/hide table
| |
| Illustration 3 | g01233326 |
Caterpillar Information System:
CX31 On-Highway Transmission Power Train Torque Converter - Assemble
CX31 On-Highway Transmission Power Train Torque Converter - Disassemble
C3.3 Industrial Engine Crankcase Breather - Remove and Install
C3.3 Industrial Engine Gear Group (Front) - Install
C3.3 Industrial Engine Gear Group (Front) - Remove
C3.3 Industrial Engine Valve Mechanism Cover - Remove and Install
C3.3 Industrial Engine Crankshaft Pulley - Remove and Install
C3.3 Industrial Engine Crankshaft Front Seal - Remove
2006/01/02 A New Water Pump is Now Used {1361}
3500B Engines Radiator Core - Install
3500B Engines Radiator Core - Remove
CX31 On-Highway Transmission Power Train Transmission and Torque Converter - Connect
C3.3 Industrial Engine Rocker Shaft and Pushrod - Install
C3.3 Industrial Engine Cylinder Head - Remove
C3.3 Industrial Engine Cylinder Head - Install
C6.6 Engines for Caterpillar Built Machines Fuel Transfer Pump
C7 and C9 Marine Engines Replacing the ECM
3126B Engine for Caterpillar Built Machines Mechanical Noise (Knock) in Engine
3126B and 3126E Truck Engines Piston and Rings
3126B and 3126E Truck Engines Piston and Rings
Application and Installation Guide for Oil/Gas Well Servicing Transmissions and Oil/Gas Well Servicing Power Systems (Mechanical Guide){1408, 1435, 3030, 3101, 7553} Application and Installation Guide for Oil/Gas Well Servicing Transmissions and Oil/Gas Well Servicing Power Systems (Mechanical Guide){1408, 1435, 3030, 3101, 7553}
C6.6 Generator Set CID 0261 FMI 11
C6.6 Generator Set E362 Engine Overspeed
C6.6 Generator Set 5 Volt Sensor Supply Circuit - Test