Removal Procedure
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
|
Note: Put identification marks on all hose assemblies and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
- Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the proper draining procedure.
Show/hide table
|
|
|
Illustration 1 | g01309879 |
- Remove clip (2) and set refrigerant accumulator (1) to the side.
Show/hide table
|
|
|
Illustration 2 | g01309894 |
- Disconnect tube assembly (3) and tube assembly (4) .
- Disconnect hose assembly (5) .
- Disconnect bracket assembly (6) .
Show/hide table
|
|
|
Illustration 3 | g01309920 |
- Remove cover (7) .
Show/hide table
|
|
|
Illustration 4 | g01309924 |
- Remove bolts (8) .
Show/hide table
|
|
|
Illustration 5 | g01309927 |
- Attach a suitable lifting device to transmission oil cooler (9). The weight of transmission oil cooler (9) is approximately 54 kg (120 lb).
- Remove bolts (10) and remove transmission oil cooler (9) and the gasket.