CID 0004 FMI 11 Cylinder #4 Injector fault
Conditions Which Generate This Code:
The Electronic Control Module (ECM) is attempting to operate the injector. The ECM detects an open or a short in the circuit for the injector.
System Response:
The ECM will log the diagnostic code. The ECM will continue to attempt to operate the injector after the code has been logged.
The injector may not operate while the condition exists.
- Engine misfires
- Low power
Test Step 1. Perform the following diagnostic procedure: Injector Solenoid Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0003 FMI 11 Cylinder #3 Injector fault
2005/10/17 New Software is Available to Add Controlled Throttle Shift Function {7620}
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0002 FMI 11 Cylinder #2 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0001 FMI 11 Cylinder #1 Injector fault
Removal and Installation of the 126-1774 Endbell Cover {7553} Removal and Installation of the 126-1774 Endbell Cover {7553}
950H Wheel Loader, 962H Wheel Loader and IT62H Integrated Toolcarrier Electrohydraulic System Main Control Valve
C11 and C13 Engines Water Pump
950H Wheel Loader, 962H Wheel Loader and IT62H Integrated Toolcarrier Electrohydraulic System Ride Control System
2005/10/24 New Rod Assembly For The Rear Access Door May Be Required {7308}
990H Wheel Loader Hydraulic System Main Control Valve
D6K Track-Type Tractor Fuses and Circuit Breakers - Replace/Reset
990H Wheel Loader Hydraulic System Ride Control System
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0005 FMI 11 Cylinder #5 Injector fault
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks CID 0006 FMI 11 Cylinder #6 Injector fault
950H Wheel Loader, 962H Wheel Loader and IT62H Integrated Toolcarrier Electrohydraulic System General Information (Electrohydraulic System)
D6K Track-Type Tractor Fuel Tank Cap Filter and Strainer - Replace/Clean
525C, 535C and 545C Wheel Skidders Grapple Grapple Cylinder Drift - Check
D6K Track-Type Tractor Ether Starting Aid Cylinder - Replace
525C, 535C and 545C Wheel Skidders Grapple Grapple Cylinder Speed - Check
D-Series and D2-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Drive Chain Case Oil - Check
C15 and C18 Engines for Caterpillar Built Machines Belt Tensioner
D6K Track-Type Tractor Engine Oil and Filter - Change
651B and 657B Wheel Tractor-Scrapers with a C15 Engine Tier III Repower Belts - Inspect/Adjust/Replace
525C, 535C and 545C Wheel Skidders Grapple Relief Valve (Line) - Test and Adjust