Engine and Machine Warm-Up
Show/hide table
NOTICE |
---|
Keep engine speed low until the engine oil pressure alert indicator goes out. If the alert indicator does not go out within ten seconds, stop the engine and investigate the cause before starting again. Failure to do so can cause engine damage. |
Show/hide table
Illustration 1 | g01101736 |
Note: The monitoring system will perform a self test when the engine is started. Always allow the monitoring system to complete the self test before you begin operating the machine.
- Allow a cold engine to warm up at low idle for at least five minutes. To help the hydraulic components to warm up faster, engage the attachment controls and disengage the attachment controls.
- Cycle all controls in order to allow warm hydraulic oil to circulate through all hydraulic cylinders and through all hydraulic lines.
- Look at the indicators and the gauges frequently during operation.
While you idle the engine, observe the following recommendations:
- Allow the engine to warm up for approximately 15 minutes when the outside temperature is higher than
0°C (+32°F) . - Allow the engine to warm up for approximately 30 minutes when the outside temperature is below
0°C (+32°F) . - More time may be required if the outside temperature is less than
−18°C (0°F) . More time may also be required if the hydraulic functions are sluggish.
Caterpillar Information System:
525C, 535C and 545C Wheel Skidders Parking Brake
525C, 535C and 545C Wheel Skidders Secondary Steering - If Equipped
980H Wheel Loader Power Train Torque Converter (Freewheel Stator)
C11 and C13 Engines Engine Oil Filter Base
980H Wheel Loader Machine Systems Hydraulic Tank - Disassemble
980H Wheel Loader Power Train Engine and Transmission Support Group
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
Machine Security System Electrical Component and Connector Locations
980H Wheel Loader Machine Systems Counterweight - Remove and Install
Machine Security System System Components
826H Landfill Compactor, 825H Soil Compactor and 824H Wheel Dozer Engine and Transmission Support Group
Machine Security System Normal Operation
525C, 535C and 545C Wheel Skidders Stopping the Engine
525C, 535C and 545C Wheel Skidders Brake Accumulator - Check
525C, 535C and 545C Wheel Skidders Transmission Oil - Change
525C, 535C and 545C Wheel Skidders Transmission Oil Filter - Replace
2004/10/04 Serviceable Parts for the Gear Pump Now Available {5073}
AccuGrade Laser System Display Icons
D9T Track-Type Tractor Machine Systems Piston Motor (Hydraulic Fan) - Remove
966H and 972H Wheel Loaders Hood Tilt
966H and 972H Wheel Loaders Roading Fender Control - If Equipped
980H Wheel Loader Machine Systems Hydraulic Tank - Assemble
D9T Track-Type Tractor Machine Systems Piston Motor (Hydraulic Fan) - Install
C15 and C18 Generator Set Engines Engine Oil Pump - Disassemble