Elevation Display Icon
The type of elevation display icon that is shown on the display depends on the operating mode that is configured. Refer to Operation and Maintenance Manual, "Modes of Operation" for more information.
The elevation display icon indicates the type of elevation information that is shown on the Display. There are two elevation display icons.
- The reference display icon indicates that the information for the reference elevation is shown.
- The cut/fill display icon indicates that the cut/fill to grade is shown.
Illustration 1 | g01101545 |
(1) Dual Mast system display screenElevation Display Icon for Reference Mode |
Illustration 2 | g01101541 |
(2) Single Mast system display screen Elevation Display Icon for Reference Mode |
Illustration 3 | g01101542 |
(3) Dual Mast system display screen Elevation Display Icon for Dual Cut/Fill Mode |
Illustration 4 | g01101543 |
(4) Single Mast system display screen Elevation Display Icon for Cut/Fill Mode |
Device Status Icons
Device status icons indicate the status of every device on the AccuGrade Laser system. The following device status icons may appear on the LCD of the Display:
Black Icons - Indicate detected devices.
Missing Icons - Indicate that the devices are not detected on powerup.
Simulated Gray Icons - Indicate devices that were previously detected, but have stopped communication while the display was powered ON.
Note: The AccuGrade - Laser System will not give grade guidance if any of the required devices are not detected.
The following illustrations describe the device status icons for the AccuGrade - Laser System.
Illustration 5 | g01106230 |
(6) The laser receiver is connected. The electric mast is connected. (7) The laser receiver is connected. The electric mast is not connected. The connection was lost since power-up. (8) The laser receiver is not connected at powerup or the device is not supported by the configuration. |
Illustration 6 | g01086127 |
(9) The laser receiver is not connected. The connection was lost since power-up. The electric mast is connected. (10) The laser receiver is not connected. The electric mast is not connected. The connections were lost since power-up. (11) The auto/manual remote switch is connected. (12) The auto/manual remote switch is not connected. The connection was lost since power-up. |
Hydraulics Available Icon
The "Hydraulics Available" icon indicates the status of the "Hydraulic Control System" for automatic operation. The display receives the hydraulic control status from the "Implement/Valve Control" ECM.
"Auto Allowed" - The icon indicates that the automatic implement control is available and that the implement control "ECM" is able to receive commands from the AccuGrade control.
"Auto Not Allowed" Icon flashes - The icon indicates that the parking brake is on. The flashing icon also indicates a fault condition that has disabled the automatic implement control.
"Disconnected" Icon is Grayed Out - The icon indicates that the implement control "ECM" is no longer communicating with the display.
"Service Mode" - The icon indicates that the hydraulics are available for servicing only.
"No Operator Detected" - The automatic implement control was deactivated because the machine was in NEUTRAL gear for more than 60 seconds without operator input.
Illustration 7 | g01048925 |
Guidance Sensor Icon
The guidance sensor for the AccuGrade Laser system is the laser transmitter. The guidance sensor icon is shown in Illustration 9.
Illustration 8 | g01101540 |
(13) Dual Mast system display screen Guidance Sensor Icon |
Illustration 9 | g01086140 |
(13) Single Mast system display screen Guidance Sensor Icon |