Rocker Shaft - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Lubricate all of the components with clean engine oil.
- Install adjusting screws (6) and nuts (5) on rocker arms (1) and rocker arms (2) .
Show/hide table
Illustration 1 | g00842949 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
Note: Inspect O-ring seal (8) for wear or for damage. If the O-ring seal is worn or damaged, use a new part for replacement.
- Position rocker shaft (7) in the end of base (9) .
- Insert rocker shaft (7) and install rocker arm (1) and rocker arm (2) .
- Slide rocker shaft (7) through washer (3) and spring (4) .
- Repeat Steps 4 through 5 in order to install the remaining components.
End By: Install the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Caterpillar Information System:
C1.5 and C2.2 Generator Set Engines Rocker Shaft - Disassemble
C15 Generator Set Engines Sensors and Electrical Connectors
3600 Distillate Fuel Engines Product Storage
2005/09/12 Improved Seal on Fuel Filter {1261}
2005/09/01 Improved Seal on Fuel Filter {1261}
C15 Petroleum Generator Set Engines Vibration Damper - Check
C175 Generator Set Engines Water Pump - Install
C1.5 and C2.2 Generator Set Engines Rocker Shaft and Pushrod - Remove
2007/07/30 Improved Seal on Fuel Filter {1261}
C175-16 and C175-20 Locomotive Engines Water Pump - Remove
C15 Petroleum Generator Set Engines Fuel System - Prime
C15 Petroleum Generator Set Engines Cooling System
C1.5 and C2.2 Generator Set Engines Rocker Shaft and Pushrod - Install
C175 Generator Set Engines Engine Oil Screen - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Sprocket - Remove and Install
C1.5 and C2.2 Generator Set Engines Cylinder Head - Remove
C15 and C18 Industrial Engines Engine Oil Pan
C32 Petroleum Engines Engine Oil Cooler - Install
2005/09/12 Make Sure to Clean the Shaft for the Engine Oil Scavenge Pump's Gear {1312}
C15 Generator Set Engines Engine Temperature Sensor Open or Short Circuit - Test
2005/09/12 Remanufactured Rocker Arm has been Changed {1123}
C1.5 and C2.2 Generator Set Engines Cylinder Head - Install
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pan
C15 Generator Set Engines Engine Pressure Sensor Open or Short Circuit - Test