C1.5 and C2.2 Generator Set Engines Caterpillar

Disassembly Procedure

Start By:

1. Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".

Show/hide table



Illustration 1	g00842949

Show/hide table

Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force.

1. Slide rocker shaft (7) from the end of base (9) .

2. Remove rocker arms (1), rocker arms (2), washers (3), and springs (4) .

   Note: Place an identification mark on each of the components for installation.

3. Remove adjusting screws (6) and nuts (5) from rocker arms (1) and rocker arms (2) .

4. Inspect all of the components from base (9) for wear or damage. If any of the components are worn or damaged, use new parts for replacement.

5. Inspect O-ring seal (8) for wear or for damage. If the O-ring seal is worn or damaged, use a new part for replacement.