Breathing ether vapors or repeated contact of ether with skin can cause personal injury. Personal injury may occur from failure to adhere to the following procedures. Use ether only in well ventilated areas. Do not smoke while changing ether cylinders. Use ether with care to avoid fires. Do not store replacement ether cylinders in living areas or in the operator's compartment. Do not store ether cylinders in direct sunlight or at temperatures above Discard cylinders in a safe place. Do not puncture or burn cylinders. Keep ether cylinders out of the reach of unauthorized personnel. To avoid possible injury, be sure the brakes are applied and all controls are in HOLD or NEUTRAL when starting the engine. |
NOTICE |
---|
Do not manually apply the ether into the intake. The heating element will incur damage if ether is sprayed directly into the intake. |
- Open the access panel on the left side of the engine enclosure.
Show/hide table
Illustration 2 g01225878 - Loosen cylinder retaining clamp (1). Unscrew ether starting aid cylinder (2).
- Remove the ether starting aid cylinder and the used gasket. Install the new gasket that is provided with the new ether starting aid cylinder.
- Install the new ether starting aid cylinder. Tighten the ether starting aid cylinder and the cylinder retaining clamp by hand.
- Install the access panel.
Illustration 1 | g01095177 |