Position Sensor (Forward/Neutral/Reverse) of Joystick Control - Calibrate
Show/hide table
 | |
| Illustration 1 | g00789705 |
Use the ET to calibrate the forward, neutral, and reverse positions of the joystick.
Calibration is required in the following situations:
- The joystick is replaced or the joystick is serviced.
- The machine ECM is replaced or the ECM is removed for service.
The ECM must detect the following conditions before starting the calibration procedure:
- The engine is off.
- There are No active diagnostic codes.
If any of these conditions are not met during the calibration, the procedure is aborted immediately.
Use the ET in order to calibrate the forward, neutral, and reverse positions of the joystick. Select Service from the main menu. Then, select "CALIBRATION" from the drop-down menu. Select the Joystick from the selection menu. Follow the instructions that are provided.
Caterpillar Information System:
AD55 Underground Articulated Truck Transmission Magnetic Screen - Clean
AD55 Underground Articulated Truck Transmission Breather - Replace
994D Wheel Loader Bucket Cutting Edges - Inspect/Replace
994D Wheel Loader Battery or Battery Cable - Inspect/Replace
3500B and 3500C Marine Engines Engine Governing - Adjust
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Fuse
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Electrical Component and Connector Locations
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Position Sensor (Steering) of Joystick Control - Calibrate
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Calibration
615C Series II Wheel Tractor-Scraper Hydraulic System Vane Pump (Elevator)
3126B Machine Engines Throttle Switch Circuit - Test
Rework of the Stabilizer Link and Tilt Cylinder Lines{5057, 5104} Rework of the Stabilizer Link and Tilt Cylinder Lines{5057, 5104}
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Position Sensor (Service Brake Pedal) - Calibrate
D3G, D4G and D5G Track-Type Tractors Capacities (Refill)
2003/08/01 A Previous High Temperature Locknut is Used in Engine Exhaust System Groups {7553}
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Forward Solenoids of Drive Pumps and Solenoids of Drive Motors - Calibrate
Bench Test Procedure for a 988G and 988H Wheel Loader Transmission {3030, 3073, 3139} Bench Test Procedure for a 988G and 988H Wheel Loader Transmission {3030, 3073, 3139}
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Reverse Solenoids of Drive Pumps - Calibrate
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Position Sensor (Deceleration Pedal) - Calibrate
2003/07/21 A New Fuel Priming Pump Is Used on the Wheel Feller Bunchers and the Wheel Skidders {1258}
AD55 Underground Articulated Truck Transmission Oil - Change
AD55 Underground Articulated Truck Transmission Oil Filter - Replace
AD55 Underground Articulated Truck Transmission Oil Level - Check
AD55 Underground Articulated Truck Turbocharger - Inspect