Position Sensor (Deceleration Pedal) - Calibrate
Show/hide table
 | |
| Illustration 1 | g00789726 |
Use the ET to calibrate the decelerator pedal sensor.
Calibration is required in the following situations:
- The decelerator pedal sensor is replaced or the decelerator pedal sensor is serviced.
- The machine ECM is replaced or the ECM is removed for service.
The ECM must detect the following conditions before starting the calibration procedure:
- The parking brake is engaged.
- The engine is running and set to high idle.
- There are No Active Diagnostics.
If any of these conditions are not met during the calibration, the procedure is aborted immediately.
Use the ET in order to calibrate the decelerator pedal sensor. Select Service from the main menu. Then, select "CALIBRATION" from the drop-down menu. Select the decelerator pedal sensor from the selection menu. Follow the instructions that are provided. See Testing and Adjusting, "Cable (Deceleration Pedal) - adjust".
Caterpillar Information System:
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Reverse Solenoids of Drive Pumps - Calibrate
Bench Test Procedure for a 988G and 988H Wheel Loader Transmission {3030, 3073, 3139} Bench Test Procedure for a 988G and 988H Wheel Loader Transmission {3030, 3073, 3139}
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Forward Solenoids of Drive Pumps and Solenoids of Drive Motors - Calibrate
2003/08/01 A Previous High Temperature Locknut is Used in Engine Exhaust System Groups {7553}
D3G, D4G and D5G Track-Type Tractors Capacities (Refill)
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Position Sensor (Service Brake Pedal) - Calibrate
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Position Sensor (Forward/Neutral/Reverse) of Joystick Control - Calibrate
AD55 Underground Articulated Truck Transmission Magnetic Screen - Clean
AD55 Underground Articulated Truck Transmission Breather - Replace
994D Wheel Loader Bucket Cutting Edges - Inspect/Replace
994D Wheel Loader Battery or Battery Cable - Inspect/Replace
3500B and 3500C Marine Engines Engine Governing - Adjust
2003/07/21 A New Fuel Priming Pump Is Used on the Wheel Feller Bunchers and the Wheel Skidders {1258}
AD55 Underground Articulated Truck Transmission Oil - Change
AD55 Underground Articulated Truck Transmission Oil Filter - Replace
AD55 Underground Articulated Truck Transmission Oil Level - Check
AD55 Underground Articulated Truck Turbocharger - Inspect
AD55 Underground Articulated Truck Body Mounting - Inspect
AD55 Underground Articulated Truck Belts - Inspect/Adjust/Replace
AD30 Underground Articulated Truck Braking System Brake Oil Overheating Troubleshooting
3126B Machine Engines Decelerator Position Sensor Circuit - Test
963C Track-Type Loader Machine Systems Refrigerant Evaporator Coil - Remove
963C Track-Type Loader Machine Systems Refrigerant Evaporator Coil - Install
D3G, D4G and D5G HYSTAT Track-Type Tractors Electrohydraulic Power Train Systems Piston Pump (Hydrostatic)