Turbocharger
Show/hide table
Illustration 1 | g01808037 |
Front view of engine |
Show/hide table
Illustration 2 | g01808036 |
Top view of engine |
Note: The oil supply and the oil drain holes should be in the vertical position with respect to the engine when the turbocharger group (1) is attached to the exhaust manifold.
Use the following procedure to tighten the clamps for the turbocharger and orient the turbocharger turbine housing and the bearing housing in order to avoid binding:
- Loosen the V-band clamps in order to rotate the turbine housing.
- Position the turbine housing with oil lines so oil lines are aligned without binding.
- Tighten the clamp assemblies to 14 ± 1 N·m (125 ± 9 lb in).
- Lightly tap around the clamp assemblies with a soft faced hammer.
- Again, tighten the clamp assemblies to 14 ± 1 N·m (125 ± 9 lb in).
Note: Apply 4C-5599 Anti-Seize Compound on the threads of six bolts (3) .
(2) Torque for eight locknuts ... 55 ± 9 N·m (41 ± 7 lb ft)
Caterpillar Information System:
C11 and C13 On-Highway Engines Engine Oil Pump
C27 and C32 Generator Sets Product Lifting
3126B Generator Set Engine Event Codes
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0708 - FMI 03
2005/12/01 Improved Valve Springs are Now Used {1100, 1108}
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 06
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 05
C11 and C13 On-Highway Engines Engine Oil Cooler
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Remove
C11 and C13 Industrial Engines Engine Oil Filter Base
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
3126B Generator Set Engine Diagnostic Codes
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0708 - FMI 05
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Install
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0708 - FMI 06
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0709 - FMI 03
C9 Marine Engines Diagnostic Code Cross Reference
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Excessive Fuel Consumption
C4.4 and C6.6 Engines for Caterpillar Built Machines Test ECM Mode
C4.4 and C6.6 Engines for Caterpillar Built Machines Injector Trim File
C-12 Generator Set Engine E169 Engine Oil Maintenance Required
C-12 Generator Set Engine E170 Fuel Filter Change Required
C11 and C13 On-Highway Engines Precooler
C-12 Generator Set Engine E264 Emergency Stop Activated