C11 and C13 On-Highway Engines Caterpillar


Engine Oil Pump

Usage:

C13 JAM



图 1g01189123


注意

起动发动机之前,机油泵必须用清洁的发动机机油润滑。 机油泵必须徒手可以自由转动。 如果机油泵没有用清洁的发动机机油润滑,可能出现驱动齿轮和泵内部结构损坏。


发动机机油泵

机油类别 ... SAE 30
机油温度 ... 50 °C (122 °F)
泵转速 ... 3045 rpm
机油压力 ... 359 kPa (52 psi)
最小机油流量 ... 155 L/min (41 US gpm)

(1) 双轴直径 ... 18.000 ± 0.005 mm (.7087 ± .0002 in)

泵体上的双轴孔径 ... 18.050 ± 0.010 mm (.7106 ± .0004 in)

(2) 密封槽

安装之前,润滑发动机前盖孔。 这会使密封槽和密封圈滑动。

(3) 驱动齿轮

加热驱动齿轮到以下温度才能安装驱动齿轮。 ... 316 °C (600 °F)

驱动齿轮直径 ... 92.28 ± 0.10 mm (3.6331 ± 0.0039 in)

(4) 密封圈

(5) 齿轮前面和壳体的间距 ... 29.40 ± 0.50 mm (1.158 ± .020 in)

Caterpillar Information System:

C27 and C32 Generator Sets Product Lifting
3126B Generator Set Engine Event Codes
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0708 - FMI 03
2005/12/01 Improved Valve Springs are Now Used {1100, 1108}
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 06
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0707 - FMI 05
C11 and C13 On-Highway Engines Engine Oil Cooler
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Remove
C11 and C13 Industrial Engines Engine Oil Filter Base
2005/08/29 A New O-Ring Seal is Now Available for the Crankcase Breather {1317}
3126B Generator Set Engine Diagnostic Codes
C6.6 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
C27 and C32 Generator Set Engines Turbocharger
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0708 - FMI 05
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Turbocharger - Install
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0708 - FMI 06
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0709 - FMI 03
C9 Marine Engines Diagnostic Code Cross Reference
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Excessive Fuel Consumption
C4.4 and C6.6 Engines for Caterpillar Built Machines Test ECM Mode
C4.4 and C6.6 Engines for Caterpillar Built Machines Injector Trim File
C-12 Generator Set Engine E169 Engine Oil Maintenance Required
C-12 Generator Set Engine E170 Fuel Filter Change Required
C11 and C13 On-Highway Engines Precooler
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.