Electronic Control Module - Remove and Install
Removal Procedure
- Remove bolts (1) and disconnect harness assemblies (2) from electronic control module (3) .
Show/hide table
Illustration 1 | g01185342 |
- Disconnect hose assemblies (4) from electronic control module (3) .
Show/hide table
Illustration 2 | g01184696 |
- Remove nut (5), ground strap (6), and isolation mount (7) .
Show/hide table
Illustration 3 | g01185271 |
- Remove bolts (9), isolation mounts (7), spacers (10), electronic control module (3), isolation mounts (7), and spacers (8) .
Installation Procedure
- Position spacers (8), isolation mounts (7), electronic control module (3), spacers (10), and isolation mounts (7) on the engine. Install bolts (9) .
Show/hide table
Illustration 4 | g01185271 |
- Install isolation mount (7), ground strap (6), and nut (5) .
- Connect hose assemblies (4) to electronic control module (3) .
Show/hide table
Illustration 5 | g01184696 |
- Connect harness assemblies (2) to electronic control module (3) and install bolts (1). Tighten bolts (1) to a torque of 6 ± 1 N·m (53 ± 9 lb in).
Show/hide table
Illustration 6 | g01185342 |
Caterpillar Information System:
2005/08/22 Troubleshooting Column-Type Fuel Level Senders {5574, 7481}
Reuse and Salvage for Fuel Injection Pumps and Nozzles on 3044, 3046, 3064, and 3066 Engines {1251} Reuse and Salvage for Fuel Injection Pumps and Nozzles on 3044, 3046, 3064, and 3066 Engines {1251}
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0100 FMI 03
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0041 FMI 04
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0041 FMI 03
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Refrigerant Condenser - Remove and Install
C4.4 and C6.6 Engines for Caterpillar Built Machines CID 1639 FMI 09
C15 On-Highway Engine Engine Valve Lash - Inspect/Adjust
C32 Petroleum Engines Aftercooler - Remove
C32 Marine and Auxiliary Marine Engines Auxiliary Water Pump - Install
C13 and C15 On-highway Engines Diagnostic Trouble Codes
C32 Marine Engines Auxiliary Water Pump - Assemble
C13 and C15 On-highway Engines Fuel Temperature Is High
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0100 FMI 04
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Mode Selection Circuit - Test
C18 Petroleum Generator Sets Engine Warm-up
C32 Petroleum Engines Aftercooler - Install
3126B Petroleum Engine Air Shutoff - Remove
C15 Generator Sets Model View Illustrations
C18 Generator Sets Plate Locations and Film Locations
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Refrigerant Compressor - Remove and Install
C7 and C9 On-Highway Engines Sensor Signal (Analog, Active) - Test
C13 and C15 On-highway Engines Sensor Signal (Analog, Active) - Test
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0100 FMI 10